Hotpoint HHC6.7AM(WH) Ventilation Hood User Manual


  Open as PDF
of 16
 
12
GB
PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24
Replacing the lights LED *
ThehoodisttedwithalightingsystembasedonLED
technology.TheLEDsensureoptimallighting,longerlife
and lower consumption compared with traditional lights. To
replace them please contact the assistance service.
Electrical cable
If the power cable is damaged, it can be replaced by the
manufacturer or his technical service, to prevent any
attendant risks.
SCRAPPING
TheunitismarkedforconformitywithEuropeanDirective
2012/19/EC,WasteElectricalandElectronicEquipment
(WEEE).Byensuringthattheunitisscrappedproperly,
the user contributes to safeguarding the environment and
public health.
The
symbol on the product or on its accompanying
documents indicates that the product may not be treated
as domestic waste but must be handed over to a sorting
centre for electrical and electronic waste. Dispose of it
inaccordancewithlocalwastedisposalregulations.For
further information on the handling, recovery and recycling
of this product, contact the local authority, domestic waste
disposal service or the reseller from whom you purchased it
Troubleshooting
If something does not work, make the following simple
checks before contacting Technical Service:
If the hood does not operate:
Checkthat:
• theunitispoweredup.
• aspeedhasbeenset.
If the hood is not working effectively:
Checkthat:
• theselectedmotorspeedissufcienttohandlethe
amount of smoke and steam being produced.
• thekitchenisadequatelyventilatedfortheunittotake
air in.
• thecharcoallterisnotexhausted(lterversion).
If the hood turns off during normal operation:
Checkthat:
• theunitispoweredup.
• thecircuitbreakerhasnottripped.
In case of faulty operation, before contacting Technical
service,rstdisconnectthemachinefromthemainsforat
least 5 seconds by pulling its plug, then reconnect it. If the
fault persist, contact Technical Service.
* Only available in certain models
 previous next