Hotpoint HM325NI Refrigerator User Manual


  Open as PDF
of 12
 
6
GB
PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR 5 YEAR PARTS GUARANTEE ON 08448 24 24 24
Using the freezer to its full potential
•Donotre-freezefoodthatisdefrostingorthathas
already been defrosted. These foods must be cooked
and eaten (within 24 hours).
•Freshfoodthatneedstobefrozenmustnotcomeinto
contact with food that has already been defrosted.
Fresh food must be stored above the grill in the
freezer compartment and if possible be in direct
contact with the walls (side and rear), where the
temperature drops below -18°C and guarantees rapid
freezing.
•Donotplaceglassbottleswhichcontainliquids,and
which are corked or hermetically sealed in the freezer
because they could break.
•Themaximumquantityoffoodthatmaybefrozen
daily is indicated on the plate containing the technical
properties located on the bottom left side of the
refrigeratorcompartment(forexample:Kg/24h:4)
! Do not open the door during freezing.
! If there is a power cut or malfunction, do not open the
freezer door. This will help maintain the temperature
inside the freezer, ensuring that foods are conserved for
at least 9 -14 hours.
! If the room temperature drops below 14°C for an
extendedperiodoftime,theidealtemperaturewill
not be reached in the freezer compartment and food
preservation will be reduced.
Ice tray
The fact that they are situated on the top part of the
freezer drawers ensures greater cleanliness: the ice no
longer comes into contact with the food placed inside
the freezer compartment; furthermore, the dripping of
the water during filling is avoided (a lid to cover up the
hole after filling with water is also provided).
1. Pull out the tray by pushing it up.
Check that the tray is ompletely empty and fill it with
water through the opening provided.
2.Takecarenottoexceedthelevelindicated(MAX
WATERLEVEL).Excesswaterpreventstheicecubes
from dispensing (if this happens, wait for the ice to melt
and empty the tray).
3. Turn the tray 90°: due to the connected compartments
each mould fills with water (see diagram).
4. Close the opening with the lid provided and put the
tray back, placing the top part in the corresponding
housing and allowing it to drop in again.
5.Whentheicehasformed(minimumtimeapproximately
8 hours) knock the tray against a hard surface and wet
the outside so that the ice cubes come loose and take
them out through the opening.
MAX
WATER LEVEL
MAX
WATER LEVEL
 previous next