Filter
Top Products
Installing your Cooker Hood
6
Top or Rear Extraction
Connect the ducting material onto the flange:
blank off the aperture which is not required.
The charcoal filter is not required when the
hood is installed in the ducting cycle.
To remove the grille turn the locks (Fig.5 B)
and pull the grille out and downwards.
Ducting:
In order to obtain satisfactory air extraction,
long ducts should not be used. Exhaust pipes
with as smooth an inner wall as possible are
recommended. The ducting MUST be
manufactured from a fire retardant material.
Wall Vent Kit:
For connecting the Hood either directly
through a wall or in conjunction with a
ducting pipe, we recommend the use of a
Wall Vent Kit. A 3m extension pipe is also
available. These may be obtained from your
nearest retailer or the Genuine Parts and
Accessories Mail Order Hotline (see back
cover) and must be used where there is a
cavity wall. Specific installation instructions
are included with the Wall Vent Kit.
NOTE:The Wall Vent Kit has a diameter of
100mm.
Fig.4
Fig.5