Filter
Top Products
Installing your Cooker Hood
8
Fixing the Hood to the Cupboards:
Place the template on the side of the right
cupboard,so that the letter B aligns with the
front part of the cupboard (disregard the
thickness of the door) and drill two holes
2.5mm diameter at points B1 and B2 (Fig.8).
Place the same template on the side of the
left cupboard ensuring that side C aligns with
the front part of the cupboard (disregard the
thickness of the door) and drill two holes
2.5mm diameter at the point C1 and C2
(Fig.9).
Fit the hood to the cupboard by means of the
screws (Fig.10 E).
Replace the visor with decor panel,inserting it
first in the upper slides and then in the lower
slides. Turn the rear locking knobs anti-clock-
wise until it stops and then mount the grille
by lifting it up - pushing inwards and turn the
locks to secure.
Once the Hood has been fixed,if the cup-
boards are deeper than the hood,mount
spacer (Fig.11 S) and secure it with the two
screws Fig.11 T) 3.5 x 13 and washers on
the back of the hood.
The spacer is reversible to cover a gap from 1
to 4cm.
Fig.8
Fig.11
Fig.10
Fig.9