Filter
Top Products
20
GB
Disposal of your product
To minimise the risk of injury to children please dispose
of your product carefully and safely. Remove all doors
and lids. Remove the mains cable (where fitted) by
cutting off flush with the appliance and always ensure
that no plug is left in a condition where it could be
connected to the electricity supply.
To help the environment, Local Authority instructions
should be followed for the disposal of your product.
Disposal of old electrical appliances
The European Directive 2002/96/EC on Waste
Electrical and Electronic Equipment (WEEE), requires
that old household electrical appliances must not be
disposed of in the normal unsorted municipal waste
stream. Old appliances must be collected separately
in order to optimise the recovery and recycling of
the materials they contain and reduce the impact on
human health and the environment.
The crossed out „wheeled bin” symbol on the product
reminds you of your obligation, that when you dispose
of the appliance it must be separately collected.
Consumers should contact their local authority or
retailer for information concerning the correct disposal
of their old appliance.
Care and Cleaning
CLEANING THE DOORS
(model: 50HEP, DSC50S,50HEG)
Take particular care not to damage the inner surface
of the door inner glass that is coated with a heat
reflective layer. Do not use scouring pads, or abrasive
powder,which will scratch the glass. Ensure that the
glass panel is not subjected to any sharp mechanical
blows.
Stubborn stains can be removed by using a fine steel
wool soap pad. For slight soiling theinner glass panel
may be cleaned, while still warm, without removing it
from the door. Aftercleaning, rinse and dry with a soft
cloth.
SIDE OPENING DOORS
Cleaning the door glass is the same as the drop down
doors, except take care to support the weight of the
inner glass when removing and refitting.
DROP DOWN DOORS
Wipe over the outer door glass panels with a cloth
wrung out in warm soapy water, then after wiping with
a cloth wrung out in clear water, dry with a soft clean
cloth. Ensure that glass doors are not subjected to any
sharp mechanical blows.
Glass Inner Door Panel (where fitted) – open the door
fully and unscrew the two screws securing the glass
panel, taking care not to allow the glass to fall. The
glass panel may now be washed at the sink. Stubborn
stains can be removed by using a fine steel wool soap
pad. Ensure the glass panel is not subjected to any
sharp mechanical blows. Take particular care not to
damage the inner surface which is coated with a heat
reflective layer. After cleaning, rinse and dry with a soft
cloth. For slight soiling the inner glass panel may be
cleaned, while still warm, without removing it from the
door.
Warning: Oven must not be operated with inner door
glass removed.
Take care during cleaning not to damage or distort
the door seals. Do not lift the door seal from the oven
chassis, if necessary remove the seal by carefully
unhooking the corner clips.
Take care that the rating label edges are not lifted
during cleaning, and furthermore that the lettering is
not blurred or removed.
Oven Lamp Replacement
Open the oven door and remove the rod shelves.
Using a suitable cloth to protect the fingers grip the
light glass dome, unscrew anti-clockwise and lift.
Reach into the aperture with fingers, and unscrew the
lamp anticlockwise. Fit replacement lamp (25W 300°C
rated SES), refit dome.
WARNING: To avoid electric shocks - please ensure
that the electricity supply to the appliance is switched
off and the appliance is fully cold, before removing the
lamp lens.
PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24