Filter
Top Products
14
CHAPTER 2 – USING THE CONTROLS AND MODES
2.1 SETTING THE CLOCK (for key references see page 5)
•When the appliance is connected to the domestic power supply for the first time, or after a power cut, four
dashes will appear on the display (----).
In order to set the clock, proceed as described below:
Press the key (6).
(The hours flash on display 1)
1
Set the desired time by turning the
knob (14).
(The hours flash on display 1)
2
Press the key (6) again.
(The minutes flash on display 1)
3
Set the desired minutes by
turning the knob (14)
(The minutes flash on display 1)
4
Press the key (6) again.
(The display shows the time set)
5
• If you wish to change the hour on the dial once it has been set, press the key (6) before proceeding
to set the new time as described above.
• It is possible to display the current time even after starting the mode set, by pressing the key (6) (the
time is displayed for 2 seconds).
GB-5719133500 13-07-2004 11:03 Pagina 14