Hotpoint RB536 Range User Manual


 
35
Installation Instructions
PREPARE TO INSTALL THE RANGE
TOOLS YOU WILL NEED
MATERIALS YOU MAY NEED
Anchor SleevesLag BoltsTin Snips
(For Anti-Tip Bracket Mounted on Concrete Floors Only)
3-Wire Cord
4‘ Long
4-Wire Cord OR
4‘ Long
(UL Approved 40 AMP)
Adjustable Wrench
Level
1/4” Nut Driver
Phillips Screwdriver
Drill with 1/8” Bit
Pencil
Safety Glasses
Tape Measure
Pliers
Flat-blade
Screwdriver
PARTS INCLUDED
Anti-Tip Bracket Kit
REMOVE SHIPPING MATERIALS
Remove packaging materials. Failure to
remove packaging materials could result
in damage to the appliance.
1
PREPARE THE OPENING
Allow 1
1
2spacing from the range to adjacent
vertical walls above the cooktop surface.
Allow 30 minimum clearance between
the surface units and the bottom of
unprotected wood or metal top cabinet,
and 15 minimum between the
countertop and adjacent cabinet bottom.
EXCEPTION: Installation of a listed
microwave oven or cooking appliance over
the cooktop shall conform to the installation
instructions packed with that appliance.
If cabinet storage is installed, reduce the
risk by installing a range hood that projects
horizontally a min. of 5beyond the
bottom of the cabinets. Make sure the wall
covering, countertops and cabinets around
the range can withstand heat generated
by the range, oven or cooktop up to 200°F.
Flooring under the range
Your range, like many other household items,
is heavy and can settle into soft floor coverings
such as cushioned vinyl or carpeting.
When moving the range on this type of
flooring, it should be installed on a 1/4
thick sheet of plywood (or similar material)
as follows:
When the floor covering ends at the front
of the range, the area that the range will
rest on should be built up with plywood
to the same level or higher than the floor
covering. This will allow the range to be
moved for cleaning or servicing.
2
Cord
Wall
Floor
7
5
C of range
L
Outlet
box
Hood
Wall
Not less than
the width of
the range
5Min.
30
Min.
15
Min.
1
1
2
Min.
Locate the outlet box
within either shaded area.
2
1
4
7
1
2
7
1
2
3
1
2
Install the
outlet box
on either
side of the
C
L
Squeeze Connector
(For Conduit
Installations Only)