Hotpoint RGA724 Range User Manual


 
Consumer Support Troubleshooting Tips Installation Instructions Care and Cleaning Operating Instructions Safety Instructions
8
Using the gas surface burners.
Throughout this manual, features and appearance may vary from your model.
Surface Lighting Instructions for Electric Ignition Models
The surface burners on some models are lit by
electric ignition, eliminating the need for standing
pilot lights with constantly burning flames.
In case of a power failure, you can light
the surface burners on your range with
a match. Hold a lit match to the burner,
then turn the knob to the LITE position.
Use extreme caution when lighting burners
this way.
Surface burners in use when an
electrical power failure occurs will
continue to operate normally.
The electrode of the spark igniter is
exposed. When one burner is turned
to LITE, all the burners spark. Do not
attempt to disassemble or clean
around any burner while another
burner is on. An electric shock may
result, which could cause you to
knock over hot cookware.
Surface Lighting Instructions for Standing Pilot Models
The surface burners on these ranges have
standing pilots that must be lit initially.
To light them:
Be sure surface burner control
knobs are in the OFF position.
Lift the cooktop up and prop it
open with the prop rod provided
(see the Care and cleaning of the
range section).
Locate the 2 pilot ports and light
each of them with a match.
To avoid pilot outage, slowly lower
the cooktop after lighting the pilots.
Surface Burner Controls
The knobs that turn the surface burners on and
off are located on the control panel on the front
of the range. The two surface knobs on the left
control the left front and left rear burners. The
two surface knobs on the right control the right
front and right rear burners.
To Use a Surface Burner
Push the control knob in and turn it
to LITE (HI on pilot models). On
electric ignition models, you will
hear a little clicking noise—the
sound of the electric spark igniting
the burner.
After the burner ignites, turn the
knob to adjust the flame size.
After Lighting a Burner
Check to be sure the burner you
turned on is the one you want to use.
Do not operate a burner for an
extended period of time without
cookware on the grate. The finish on
the grate may chip without cookware
to absorb the heat.
Be sure the burners and grates are
cool before you place your hand, a
pot holder, cleaning cloths or other
materials on them.
Pilot port