Filter
Top Products
12
Before placing foodstuffs in the refrigerator or freezer,
clean the interior well with warm water and baking soda.
After having plugged the appliance in, make sure that
pilot lamp is light.
Set thermostat knob onto a medium position and can
place food in the fridge after only a few hours.
When the freezer has reached the optimum
temperature, you can place frozen food in the freezer.
Earthing
Before making the electrical connection, check that the
voltage shown on the data plate, that you will find on the
bottom left hand side of the appliance next to the crisper,
corresponds to that of your mains and that the socket is
earthen in conformity with all current electrical
regulations. If the system is not earthen, the
manufacturer declines all liability for consequent
damages or losses. Do not use adapters or multiple
sockets.
Check the power load
The electrical socket must support the maximum power
load of the appliance shown on the data plate (on the
bottom left hand side of the appliance next to the
crisper).
Before plugging the appliance to the mains
Set the appliance upright and wait at least 3 hours
before plugging the appliance into the mains to ensure
proper performance.
Proper installation of the appliance is essential to
ensure the best and most efficient performance of
your appliance.
Ventilation
The compressor and condenser generate heat and,
therefore, need to be ventilated properly. Rooms with
less than perfect ventilation are not very suited for
installation of the appliance. Therefore, it should be
installed in a room with an opening (window or French
window) that provides the appropriate amount of air re-
circulation. It is also important that the room should not
be too humid.
During installation, make sure not to cover or obstruct
the grates that allow proper ventilation of the appliance.
For proper ventilation of the appliance, you must leave:
- a space of at least 10 cm between the top part and any
cabinets above it;
- a space of at least 5 cm between the sides of the
appliance and any adjacent cabinets/walls.
Away from Heat
Avoid positioning the appliance in a place where it is
directly exposed to sunlight or near an oven, cook top or
the like.
Levelling
The floor should be perfectly levelled; if not, you can
adjust the feet at the front of the appliance.
Ïîñòîÿííî ðàáîòàåò êîìïðåññîð
Ïðîâåðüòå, ÷òî:
-äâåðöû õîëîäèëüíèêà ïëîòíî çàêðûâàþòñÿ è
îòêðûâàþòñÿ íå ñëèøêîì ÷àñòî;
-òåìïåðàòóðà â ïîìåùåíèè íå ñëèøêîì âûñîêàÿ;
-ðó÷êè òåðìîðåãóëÿòîðîâ íàõîäÿòñÿ â ïðàâèëüíîì
ïîëîæåíèè.
Õîëîäèëüíèê ñëèøêîì øóìèò ïðè ðàáîòå
Ïðîâåðüòå, ÷òî:
-õîëîäèëüíèê âûðîâíåí;
-õîëîäèëüíèê íå êàñàåòñÿ ïîñòîðîííèõ ïðåäìåòîâ
(íàïðèìåð, îêðóæàþùåé ìåáåëè).
Õëàäàãåíò, öèðêóëèðóþùèé âíóòðè ñèñòåìû
îõëàæäåíèÿ, ìîæåò íåãðîìêî áóëüêàòü, äàæå åñëè
êîìïðåññîð íå ðàáîòàåò. Íå áåñïîêîéòåñü, ýòî
ñîâåðøåííî íîðìàëüíî.
Åñëè ïîñëå ïðîâåðêè õîëîäèëüíèê ïðîäîëæàåò
ðàáîòàòü íå äîëæíûì îáðàçîì, ñâÿæèòåñü ñ
àâòîðèçîâàííûì ñåðâèñíûì öåíòðîì,
îáñëóæèâàþùèì ïðîäóêöèþ ìàðêè ARISTON.
 ñëó÷àå íåóäîâëåòâîðèòåëüíîé ðàáîòû
õîëîäèëüíèêà èëè âîçíèêíîâåíèÿ íåèñïðàâíîñòåé
ïðî÷èòàéòå ýòîò ðàçäåë, ïðåæäå ÷åì âûçûâàòü
òåõíèêîâ.  áîëüøèíñòâå ñëó÷àåâ Âû ìîæåòå
ðåøèòü âîçíèêøèå ïðîáëåìû ñàìè.
Õîëîäèëüíèê íå ðàáîòàåò
Ïðîâåðüòå, ÷òî :
-â äîìå íå îòêëþ÷åíî ýëåêòðè÷åñòâî;
-ñâåòèòñÿ èíäèêàòîðíàÿ ëàìïî÷êà;
-âèëêà íàäåæíî âñòàâëåíà â ðîçåòêó;
-ðîçåòêà èñïðàâíà; äëÿ ïðîâåðêè ïîäêëþ÷èòå
óñòðîéñòâî, â èñïðàâíîñòè êîòîðîãî Âû óâåðåíû.
Òåìïåðàòóðà â îòäåëåíèÿõ õîëîäèëüíèêà
ñëèøêîì âûñîêàÿ
Ïðîâåðüòå, ÷òî:
-äâåðöû îòäåëåíèé çàêðûòû ïëîòíî, óïëîòíåíèÿ íà
äâåðöàõ íå ïîâðåæäåíû;
-ðó÷êà òåðìîðåãóëÿòîðà íàõîäèòñÿ â ïðàâèëüíîì
ïîëîæåíèè;
-îòäåëåíèÿ íå ïåðåïîëíåíû ïðîäóêòàìè;
-äâåðü îòäåëåíèÿ íå îòêðûâàëè ÷àñòî.
Ïðîäóêòû â õîëîäèëüíîì îòäåëåíèè
ïåðåîõëàæäàþòñÿ
Ïðîâåðüòå, ÷òî:
-ðó÷êà òåðìîðåãóëÿòîðà íàõîäèòñÿ â ïðàâèëüíîì
ïîëîæåíèè.
9
Íåèñïðàâíîñòè è ìåòîäû
èõ óñòðàíåíèÿ
Installation
CIS
CIS
GB
Positioning and connection