Filter
Top Products
GB
5
The first time you use your appliance, heat the empty
oven with its door closed at its maximum temperature
for at least half an hour. Ensure that the room is well
ventilated before switching the oven off and opening
the oven door. The appliance may emit a slightly
unpleasant odour caused by protective substances
used during the manufacturing process burning away.
The Control panel lock and DEMO mode can be
activated/deactivated even when the control panel is
switched off.
Control panel lock
To lock the oven controls, press and hold the
and buttons for 5 seconds. A buzzer sounds
and the TEMPERATURE display shows r-0.
Press again to unlock the controls. The STOP
button is always active.
Demo mode
The oven can operate in DEMO mode: all heating
elements are deactivated, and controls remain
operative.
To activate the DEMO mode, press the
, ,
and buttons simultaneously.
To deactivate the DEMO mode, press the
, ,
, and buttons at the same time. A buzzer
sounds and the display shows demo off.
Setting the clock and timer
After the appliance has been connected to the
electricity supply, or after a blackout, the
button
will begin to flash.
To set the time:
1. Adjust the hour figure using the + and -
buttons on the right hand side of the control panel
within 8 seconds.
2. Press the
button again.
3. Adjust the minutes using the + and - buttons
on the right hand side of the control panel.
4. Wait at least 8 seconds for the setting to be
memorised or press the
button again.
To make any necessary changes, switch on the
control panel by pressing the
button, then press
the
button and follow the steps described.
When the set time has elapsed, a buzzer will sound.
The buzzer will automatically stop after 6 seconds or
when any active icon on the control panel is pressed.
To set the timer, press the
button and follow the
procedure used to set the clock. The
button will
indicate that the timer has been activated.
The timer does not switch the oven on or off.
Starting the oven
1. Press the button to switch on the control panel.
2. Press the symbol which corresponds to the
desired cooking mode. The displays show the
duration and temperature of the selected cooking
mode.
3. Press the START button to begin cooking.
4. The oven will begin its preheating phase, and the
current preheating temperature indicator lights turn
red. The temperature may be adjusted by pressing
the + and - buttons on the right hand side of the
control panel.
5. When the preheating stage is complete, a buzzer
sounds and all current preheating temperature
indicator lights are illuminated: place the food in the
oven.
6. During cooking it is always possible to:
- Change the temperature by pressing the + and -
buttons on the right hand side of the control panel.
- Set the duration of a cooking mode (see Cooking
Modes).
- Press the STOP button to interrupt cooking.
7. The oven switches off automatically after two
hours: this default time is set for all cooking modes
for safety reasons.
The cooking time may be modified (see Cooking
Modes).
8. If a blackout occurs while the oven is already in
operation, an automatic system within the appliance
will reactivate the cooking mode from where it was
interrupted as long as the temperature has not
dropped below a certain level. Programmed cooking
modes which have not started will not be restored
and must be reprogrammed.
There is no preheating stage for the BARBECUE
mode.
Never put objects directly on the bottom of the
oven; this will avoid the enamel coating being
damaged.
Always place cookware on the rack(s) provided.
Cooling ventilation
In order to cool down the external temperature of the
oven, a cooling fan generates a stream of air which
escapes between the oven control panel and the
oven door.
Once the cooking has been completed, the cooling
fan continues to operate until the oven has cooled
down sufficiently.
Start-up and use