Filter
Top Products
CONNECTION TO THE GAS SUPPLY
The supply system must be
compliant with the current
standards in the country of
use. The type of gas for which the oven has been regulated is indicated on the serial
number plate located on one o
f the side edges of the cavity (visible with the door
open) and on the packaging. Before carrying out the connection, the oven must be
adapted to the type of gas that will be used.
L
ink
the
male cylindrical threaded pipe
-
fitting
½"G,
which
is placed on the back
side of the appliance to the supply, by using
a
non
-
flexible metallic pipe
and pipe
-
fittings
which are
compliant with the current standards
.
O
the
r
wise
you can use a flexible metallic pipe
entirely
fixed to the wall
and pipe
-
fittings
which are
compliant with the current standards
; the
length of the
pipe can
not
be
over
2000 mm
, in compliance with the current standards.
C
heck
that
the pi
pe
cannot come in contact with movable parts that could damage it.
Place the seal (fig. 1)
between the pipe
-
fitting and the pipe.
T
he
seal is provided
with the appliance.
I
mportant
:
to conenct the appliance to a LPG supply, place a pressure regulator
which is
compliant with the current standards
between the pipe and the gas tank.
Attention:
when finished, check that there are no gas leaks.
Use soap and water or special liquids to
make sure that there are no gas leaks.
DO NOT USE OPEN FLAMES WHEN SEARCHING FOR GAS LEAKS.
Warning:
the use of a rubber flexible hose fastened with hose clamps is prohibited
because it cannot be inspected.
Fig. 1
Ramp (pipe-fitting) Seal Gas pipe
______
______
______
GB
8