Filter
Top Products
GB
2
Installation
! It is important that you keep this user guide handy so
that you can refer to it at any time. Should you sell,
give away, or move the wine cellar, please make sure
that this user guide is with it.
! Read this user guide thoroughly. It contains important
information about how to use this wine cellar, how to
install it, and how to operate it safely.
! Should you need to move the wine cellar, keep it in a
vertical position.
Location and Power Connection
Remove packaging
1. Immediately remove the packaging and check to
make sure your wine cellar has not been damaged
during transportation. If it is damaged, contact your
Retailer immediately.
2. Carefully remove the packaging and stickers that
protect the product. Open the door and check the
components to make sure they are not damaged.
3. Take out the power cable.
Location
1. The wine cellar should be located in a well-ventilated,
non-humid open area (do not place it in closets).
2. Place the wine cellar far away from any heat sources.
Power Connection
After transportation, let the wine cellar stand in its
intended location for at least 3 hours before you plug it
in. Before the power is connected, make sure of the
following:
• the wall-outlet should be grounded (earthed) and it
must meet the local electric code;
• the wall-outlet should be sufficiently rated to supply
the wine cellar's maximum power consumption,
indicated in the Technical Information on the right or
on the wine cellar's data plate on the bottom right
(
see Product Description
);
• the voltage should be as indicated in the
Technical Information or on the wine cellar's
data plate on the bottom right (
see Product
Description
);
• the wall-outlet should be compatible with the wine
cellar's plug. If not, replace the outlet or the plug.
Do not use extension cords or power strips.
! Once installed, the power cord and the plug must be
easy to access.
! The power cable should never be crushed or bent.
! The power cord should be regularly checked and, if
necessary, replaced only by a qualified technician.
! The manufacturer cannot be held responsible if these
procedures are not followed.
TECHNICAL INFORMATION
Model WE26
Temperature 1 Zone
Width cm 59
Measurements Height cm 68
Depth cm 56,2
Weight** 76 Kg
Weight 97 kg
Wattage 120 W
Energy Consumption 0,9 kWh / 24h
Voltage* 220 V
Frequency* 50 Hz
* These values will vary for each country. For
specific product characteristics, check the wine
cellar's data plate.
** When empty.