Filter
Top Products
EXISTING FAN
D11
E
D12
D13
2
1
D14
E
D15
15
Existing Construction – accessible only from below
Pull wires through strain relief.
Remove an existing fan and check to make sure the open-
ing is large enough to accommodate the new motor hous-
ing (8”x 8.5”).
Move the housing into position above the ceiling.
Attach existing ducting to duct connector. Tape joints.
If ducting does not fit securely,
an adapter may need to be purchased.
Install the housing flush with the sheetrock and secure by
tightening the pre-loaded screws into the joist.
41719-01 3/29/2006 41719-01 3/29/2006
41719_EngS_3.29.06.indd 15 3/29/06 9:16:52 PM