Hunter Fan 90066 Ventilation Hood User Manual


 
B20
F
1
2
F
B21
2
G
B22
B23
H
B24
H
B25
I
B26
ON
OF
F
B27
B28
E1
Go to step
on page 18
to attach grille.
Install the wiring cover plate. Make sure all
wiring connections are inside the box or under
the wiring cover plate.
Tighten the wiring cover plate screw.
Reinstall the motor by inserting the tabs and pushing up
into position. Make sure the wires are not pinched
between the motor and the housing.
Secure the motor by tightening the 2 screws.
Test the motor. If the motor does not run, check the plug
connection.
Turn on the power source.
Connect 4” duct and vent to the outside. Tape joints.
If ducting does not fit securely, an adapter may need
to be purchased.
Connect wiring from the motor to the wiring cover plate.
10
11
Existing Construction – accessible from above
EXISTING FAN
C11
Remove an existing fan and check to make sure the
opening is large enough to accommodate the new
motor housing (9”x 9.75”).
NO EXISTING FAN
Use the motor housing as a template to mark position.
OR
41723-01 12/25/2004 41723-01 12/25/2004