Filter
Top Products
www.HunterFanInternational.com
Rocker- Style
Plate
Switch Cover
Plate
Removed
Tabs
To install the transmitter cradle, remove
the two screws holding the switch
cover plate. Do not remove the cover
plate. Orient the cradle by lining up
the two mounting holes with those on
the cover plate. Insert and tighten the
screws. Do not over tighten.
Note: For rocker-style cover plates,
break off the tabs by pushing outward.
To turn on fan, press a fan speed
button. Speeds range from off (0)
to high (3). Quickly press the Light
button to turn the lights off and on.
Hold the Light button to raise and
dim the light level.
Medium
Speed
Light
High
Speed
Fan
Off
Low
Speed
Operation, Maintenance, & Cleaning
ON
Turn Power
To access the battery compartment,
remove the small Phillips head screw
that secures the battery door to the
transmitter assembly. The battery
should be installed with the positive
(+) side up. Replace with a CR2032
battery when necessary.
Phillips
Head
Screw
Battery
Door
The remote transmitter should already be
paired to the receiver and ready to use.
Note: If your need to pair your remote,
turn fan power off and back on at the wall
switch. Within 3 minutes, press and hold
both the Fan Off button and the High
button for 4 seconds to pair the remote.
To prevent faulty operation, please
ensure all other ceiling fans within
range are turned off at the wall switch
while pairing.
17
MB517-01 • 03/10/15 • © Hunter Fan Company