Husqvarna QC 620 Ventilation Hood User Manual


 
34
2
1
A
B
Fig. 2
Cleaning the motor cover
It is also possible to clean the motor cover (Fig. 2):
Remove the grease filter.
Remove the inlet ring (A) by turning it anti-
clockwise.
Remove the fan wheel by unscrewing the centre nut
(B) on the fan wheel.
Use gloves when removing the fan wheel. Clean all the
plastic and metal parts with warm water and washing
dergent. Replace in reverse order.
If the cooker hood does not function
Fig. 3
Cleaning/changing the carbon
filter
Unlike other carbon filters, the LONG LIFE
carbon filter can be cleaned and reactivated. The
filter should be cleaned every other month if used
normally. The filter is best cleaned in a dishwasher
at the highest temperature using normal washer
detergent. The filter should be washed on its own
to prevent particles of food from fastening in it and
then causing an unpleasant smell later on. To
reactivate the carbon the filter should be dried in
the oven. Chose upper/lower heat and maximum
100° C and dry the filter for 10 minutes. Read also
the filter instructions.
The filter should be changed after about 3 years as
its ability to absorb smells has reduced by then.
The filter insert is removed from the frame and is
replaced with a new one (according to the filter
instructions).
Before calling for service
Check the plug is correctly connected to the wall
socket. Check the fuse. Do not attempt any repairs
yourself that are likely to lead to further damage. If the
problem remains, contact your dealer or an approved
service company. Remember to save your purchase
receipt and warranty card (only used in some
countries).
Service and spare parts
Your dealer or service company will supply you
with service and spare parts. Be sure you have the
product number and model name at hand when
ordering service or parts.
Changing the light
Turn off the power before changing the light.
Remove the lampglass by pushing the two snaps
forwards (Fig. 3).
Replace the damaged part with one of equal
rating.
To remove the light without damaging it, place a
finger on the end of the light and pull gently.
Changing the cord
If the cord to the cooker hood is damaged it must
be replaced by an approved service company. This
is because special tools are required for the job.