Filter
Top Products
IGHT-RHR, RHR2-HEX-0608
10
Cleaning Instructions
1 . Turn temperature control knobs to OFF position.
2. Allow unit to cool completely.
3. Wipe entire unit with clean cloth and mild detergent.
The EXTERIOR surfaces of these hot tables must be
cleaned with a mild detergent and warm water to protect
and maintain their attractive nish. Never use abrasive
cleaners or scouring pads.
TO REMOVE “BAKED-ON” SPLATTER, GREASE OR
LIGHT DISCOLORATION TO STAINLESS STEEL.
CLEANSING AGENT APPLICATION
Grade F Italian Pumice........Scour or rub with damp cloth
Liquid NuSteel.....................Scour with small amount on
dry cloth
Paste NuSteel
Household Cleansers...........Rub with damp cloth
TO REMOVE HEAT TINT OR HEAVY
DISCOLORATION
CLEANSING AGENT APPLICATION
Allen Stainless Steel Polish........Small amount on damp
cloth
Birdsall “Staybright” ...................Rub with damp cloth
Wyandotte
Bab-O
Nusteel.......................................Rub with stainless steel
wool
Plexiglass and Acrylic Care
Cleaning
Clean with plenty of nonabrasive soap (or detergent) and
lukewarm water, using the bare hand to feel and dislodge
any caked-on dirt. A soft, grit-free cloth, sponge, or chamois
may be used, but only as a means of carrying the water to
the plastic. Dry with a clean damp chamois or clean soft
cloth such as cotton annel. Hard, rough cloths or paper
towels will scratch the acrylic and should not be used.
Waxing
If after removing dirt and grease, the acrylic can be waxed
with a good grade commercial wax. This will improve
the appearance of the surface by lling in most minor
scratches. Wax should be applied in a thin even coat, and
brought to a high polish by rubbing lightly with a dry clean
soft cloth, such as a cotton annel. Excessive rubbing may
cause scratching and/or buildup an electrostatic charge,
which attracts dust and dirt to the surface. Blotting with a
clean damp cloth is recommended to remove charge.
Antistatic Coatings
For acrylic used indoors, antistatic coatings successfully
prevent the accumulation of electrostatic charge for periods
of several months, if the surface is not washed or wiped
down with a wet cloth. Between applications of the antistatic
coatings, the parts need only be dusted with a soft clean
cloth to maintain a good appearance. In use, liquid antistatic
coatings should be applied in a very thin even coat. If beads
appear as it is applied, the coat is too thick and the excess
should be removed with another cloth. Allow the coating to
dry, then bring to a high gloss with a soft cloth.
Cleaning Precautions
To preserve the attractive nish, use warm water and a mild
detergent to wash the exterior of the cases. DO NOT USE
ABRASIVE CLEANERS OR STEEL WOOL SCOURING
PADS as these will mar the surface.
User Information (Cont'd)