Filter
Top Products
Utility Connections CD300
Page 6
Drain Connections -Follow all applicable codes.
As ice melts in the dispenser, the water must be drained away. It is critical that a proper drain be
connected to the dispenser. Remember that this is a gravity drain system, the drain tubing must
slope down a minimum of ¼ inch per foot of horizontal run. Usually an air gap must be established
between the end of the drain tube and the building’s drain receptacle. The dispenser’s vented
drain must be separate from the drain used by the ice machine.
Electrical Connections - Follow all applicable codes.
There is a junction box on the back of the dispenser, connect the power supply to the wires inside
the junction box. Be certain that the ice machine and dispenser are grounded.