Filter
Top Products
Environmental Protection/ Conservation Issues
Your washing machine uses water, energy and detergent efficiently,
thereby protecting the environment and reducing your household costs.
Using your washing machine in an efficient and environmentally
friendly manner:
Do not exceed recommended load.
Cottons 5.0kg
Easy-care 2.5kg
Add detergent according to the degree of soiling, amount of laundry and
water hardness, and observe the dertergent manufacturer’s
instructions.
Before Using Your Washing Machine For The First
Time
Caution
The washing machine must have been installed and connected properly
(refer page 7)
Your appliance was tested before leaving the factory. To remove any
water left over from testing procedures, the first washing cycle should
be carried out without laundry in the machine.
Do not load any laundry.
1. Turn on water tap.
2. Pull out the detergent dispenser up to the end stop.
3. Pour approx. 1 litre of water into chamber II of the detergent
dispenser.
4. Pour ½ measuring beaker of detergent into dispenser II.
5. Close the detergent dispenser.
6. Set the programme to cottons and start the machine.
7. After the program is over turn OFF the machine.
12
Why Does It Happen ?
WATER DOES NOT ENTER MACHINE/DETERGENT NOT
BEING FLUSHED INTO DRUM.
qCheck water supply
qPorthole door not firmly closed
qWater tap not turned on
qBent inlet hose
qSieve on inlet valve clogged
SUDS ESCAPING FROM DETERGENT DISPENSER TRAY./
EXCESSIVE FOAM IN THE DRUM.
qDetergent used is not a washing machine
detergent
qExcessive detergent used
WATER LEAKAGE FROM THE MACHINE.
qInlet / Outlet hose connection loose
qFluff Filter not screwed on properly
qInlet hose leaking
qDrain plug not fixed properly onto Drain hose.
MACHINE DOES NOT DRAIN.
qFluff Filter clogged
qOutlet hose end above 1 meter from floor level
MACHINE VIBRATES STRONGLY DURING SPINNING.
qMachine not levelled properly
qClothes not loaded as instructed
qwater not drained completely
MACHINE DOES NOT START.
qCheck position of programme selector knob
qCheck water supply
qPorthole door not closed properly
MOTOR NOISE.
qIt is normal for noises to be heard while motor is running.
However wash load, belt tension and motor mounting
bolt should be checked for specified limits.
PUMP NOISE.
qIt is normal for noises to be heard from the pump during
the start- up and final stage of draining. However
check for fluff filter clogging.
FAULT DIAGNOSIS
25