Filter
Top Products
Programme Selection
1. COTTONS
To be used for whites and coloureds of cotton or
predominantly of cotton in case of mixed load.
STAGE I : Main Wash - Heavy wash/Normal wash/Quick wash
qClothes are soaked, tumbled in water with detergent to
remove dirt. Clothes are tumbled to expose more
surface, before draining out dirty water.
qIF CLOTHES ARE NOT VERY DIRTY, THE WASH CYCLE
CAN BE STARTED BY DIRECTLY SETTING THE
PROGRAMME SELECTOR KNOB AT NORMAL OR QUICK
WASH, TO REDUCE WASHING TIME.
STAGE II : Rinse
qAfter washing, the rinsing is done automatically four
times to remove traces of detergent and dirt from
clothes.
qFor most efficient rinsing, two intermittent short spins are
provided.
STAGE III : Intensive Spin Drying
qSpin drying takes place at 600 rpm for longer duration.
14
Drum
Rust Stains
Never leave metal items e.g. paper clips, safety
pins etc. in he drum as it creates superficial rust
marks in drum. If there are any rust stains
remove with a non-chlorine agent. Special non-
metal sponges (never use steel wool ) may also
be used.
Sieves
Cleaning of Water connection Sieves, filter
1. Turn off Taps. Disconnect Power supply to the
machine. Unscrew inlet hose from machine
as well from the tap and drain out water from
the hose.
2. Pull the sieve out of the magnetic valve with a
pair of flat nosed plier and clean under running
water with a brush. Fit Sieve back to the Valve.
3. Remove the filter mesh from the tap end of the
inlet hose and clean under running water with
a brush.
4. Fit the filter mesh back to inlet hose.
5. Screw inlet hose back to the machine and the
tap. Ensure that both the sieves and the filter are
in place.
6. Turn on the tap.
Cleaning of Porthole Door Area:
qAfter every wash clean vapour off porthole
door.
qLift the fold in the rubber gasket under
porthole periodically to remove lint and dirt
preferably after every wash.
23