Cornelius DF250 Ice Maker User Manual


  Open as PDF
of 3
 
Ice Slide for ED/DF200/250 Units Installation Instructions
Publication Number: 629088508INS - 2 - © 2004, IMI Cornelius Inc.
5. Loosen and remove agitator retainer inside hopper area (see FIGURE 2). Remove agitator from
motor shaft and turn ‘upside down’ inside hopper to ‘hang’ agitator from front left lip of icemaker
adapter (see FIGURE 3). Note: agitator will remain inside hopper area during installation of ‘ice
slide’.
FIGURE 2. Agitator Inside Hopper FIGURE 3. Hook Agitator to Front Lip of Adapter
6. From inside Hopper, using pliers, position ‘ice slide’ to match cut-out in hopper (see FIGURE 4) and
set front ledge of ‘ice-slide’ inside cut-out and push down on backside. Ice slide should ‘snap’ into
cut-out in hopper. Retaining clips (see FIGURE 5) on ‘ice-slide’ should extend under the hopper
surface.
FIGURE 4. Position Ice Slide Inside Hopper FIGURE 5. Ice Slide (Backside)
 previous