Filter
Top Products
Non-Carbonated Impulse Installation & Operations Manual
Publication Number: 859000159INS - 2 - © 2003, IMI Cornelius Inc.
INSTALLATION
CAUTION — Only trained and certified electrical, plumbing and refrigeration techni-
cians should service this unit. ALL WIRING AND PLUMBING MUST CONFORM TO
NATIONAL AND LOCAL CODES.
NOTE: Water pipe connections and fixtures directly connected to the potable water supply must
be sized, installed, and maintained in accordance with NSF Standard 18, as well as Federal, State,
and Local codes.
NOTE: It is the installer’s responsibility to ensure that the water supply is equipped with protec-
tion against backflow. This protection can be an air gap as defined by ANSI/ASME A112.1.2-1979,
or by an approved vacuum breaker or other approved method.
INSTALLATION REQUIREMENTS
Requirements Summary
Weight:.................front or rear counter must be level and able to support 400 lbs.
Environment:........indoor installation only
Temperature:........40 to 110° F ambient temperature
Clearance:............18-inches above
6-inches on sides and rear
CO
2
:.....................75 psi (5.25 bar) at unit with internal carbonator
Concentrate: ........60 psi
Water:...................50 psi maximum
Electrical: .............see nameplate on unit for electrical requirements
Electrical Requirements
Before connecting electrical power to the unit refer to nameplate to verify power requirements.
DANGER — To avoid possible serious injury or death the ELCB (earth leakage circuit
breaker) must be installed in electrical circuit of all 50 Hz units.
WARNING — To avoid possible electrical shock the unit must be electrically grounded
using the green grounding screw provided inside the electrical contractor box.
CAUTION — The wiring must be properly grounded and connected through a 10-amp
disconnect switch (slow–blow fuse or equivalent HVAC/R circuit breaker). ALL WIRING
MUST CONFORM TO NATIONAL AND LOCAL CODES. MAKE SURE UNIT IS PROP-
ERLY GROUNDED.