Filter
Top Products
10
Installation
Important: always unplug the appliance from the mains
before making any adjustments or carrying out
maintenance work.
Installing built-in ovens
To ensure the proper working order of the built-in appliance,
the kitchen unit must be of a suitable size. The sizes of
the unit for installing the cooker under a worktop or in a
column unit are shown in figure.
595
mm.
595
mm.
20
mm.
543
mm.
567
mm.
45
mm. min
558
mm. min
593
mm. min
23
mm.
5
mm.
23
mm.
567
mm.
595
mm.
575-585
mm.
595
mm.
45
mm. min
45
mm. min
558
mm. min
595
mm.
20
mm.
543
mm.
5
mm.
To ensure proper ventilation, the back panel of the unit
must be removed. The cooker should be placed on two
small wooden boards; should there be a one-piece
worktop, there must be an opening of at least 45 x 600
mm.
560 mm.
45 mm.
To secure the cooker to the unit, open the oven door and
fix the cooker by screwing the 4 wooden screws into the 4
holes located in the outer frame.
The unit panels next to the cooker must be heat resistant.
In the case of veneered wood units, glues must be resistant
to a temperature of 100 °C. In accordance with safety
standards, once the appliance has been mounted, there
must be no possible contact with electrical parts. Any
protective parts must be secured so that they can only be
removed with the use of tools.
Electric connection
Cookers with a three-pole power supply cable are
designed to operate with alternated current at the supply
frequency and voltage indicated on the data plate (at the
bottom of the oven dashboard). The earthing conductor
of the cable is the yellow-green conductor.
V
Fig. A Fig. B
Feeding cable installation
Terminal block opening:
• Unscrew screw “V” (Fig. A).
• Pull and open the junction block lid.
For the installation of the feeding cable carry out the
following operations Fig. B:
• unscrew the screw of the cable stop and the three
screws of the contacts L-N-( ).
• Fix the small cables under the heads of the screws
remembering to observe the colours: Blue (N) Brown
(L) Yellow-Green ( ).
• Fix the feeding cable in the special cable stop and close
the cover.
Connecting the power supply cable to the mains
The appliance must be directly connected to the mains
using an omnipolar circuit-breaker with a minimum contact
opening of 3 mm installed between the appliance and the
mains, suitable for the load indicated and complying with
current directives (the earthing wire must not be interrupted
by the circuit-breaker). The power supply cable must be
positioned so that it does not exceed 50°C more than room
temperature at any point of its length. Before making the
connection check that: