Filter
Top Products
Property Damage: Do not pinch or break copper
tubing. Do not distort the last 1 inch of tubing.
■■ From under the sink, place the
semi-circular mounting plate onto
the threaded stud.
■■ Place hex nut onto the threaded stud.
Ensure faucet head is at desired angle.
■■ Insert screwdriver into hole on side of
hex tool (creating a “T”), and use tool
to tighten nut and secure faucet.
2
Semi-circular mounting plate should
encircle all descending tubes and
extend beyond sink hole when tight.
■■ Ensure that the black O-ring is
properly seated in the base of the
dispenser head (the groove on the
underside of the dispenser).
■■ Feed tubes down through the hole
in the sink or countertop until the
base is at rest on the sink or
countertop surface.
■■ Unpack dispenser components.
■■ On a firm, flat surface, carefully
straighten the copper tubing.
An assistant may be needed to hold
the dispenser head in place
while securing the dispenser.
B
A
C
D
Make sure to use rubber O-ring
to ensure proper seal.
INSTALLING THE FAUCET
6