Filter
Top Products
10
Scalding Hazard: Do not allow
water to boil. May result in
severe burns.
Factory temperature
pre-set is 190
˚F.
■■
Disconnect power
from unit.
■■
To adjust water
temperature you’ll
need to access the panel on the front of
the tank. Using a screwdriver, turn
thermostat screw clockwise to increase
temperature or turn counter clockwise to
decrease temperature. The cover must
always be in place for the thermostate to
respond properly.
■■
After adjusting, depress the dispenser
handle for 20 seconds for the water to
re-heat to the new setting. If temperature
still is not to your liking, repeat the procedure
making sure that the handle is depressed
for 20 seconds.
■■
Regularly inspect the unit for any signs of
leakage. If there are signs of water damage,
immediately remove the unit from service.
■■
To avoid water damage from leakage,
replace all cut, loose or split tubing
.
■■
A drain pan, plumbed to an appropriate
drain or outfitted with a leak detector,
should be used in those applications where
any leakage could cause property damage.
PROPERTY DAMAGE
CARE AND USE
ADJUSTING THE THERMOSTAT
■■
Only use mild cleaners to clean the faucet
and plastic components.
■■
Cleaners with acids, abrasives, alkaline
or organic solvents will result in deterioration
of the plastic components and void
the warranty.
CLEANING THE FAUCET AND TANK
Anytime the instant hot water dispenser is not used
for extended periods of time, unplug and drain unit.
If it is below freezing you will need to unplug the
unit and drain it.
■■
Disconnect power from unit.
■■
Push hot water dispenser faucet lever
and allow water to flow until it is cool.
■■
Shut the cold water flow off at the
shut off valve.
■■
Remove unit from sink and turn upside
down to drain.
SEASONAL STORAGE/DRAINAGE
11
Property Damage: To avoid water damage, replace any loose or split tubing.
Periodically inspect the unit for any signs of leakage and immediately remove from
service any unit suspected of leaking.
Personal Injury: This tank is a non-pressurized tank. DO NOT modify this system.
DO NOT close vent tube or connect other type dispensers or valves to the tank. Use only
the InSinkErator dispenser faucet supplied. Use only parts provided. Contact an
authorized InSinkErator Service agent for repairs or replacement components.
Electric Shock Hazard: Using an ungrounded or improperly connected appliance can
result in serious injury or death from electrical shock.
1-Year Warranty
Covers all replacement parts and labor to correct defects in material or workmanship in the
dispenser system, for the full warranty period from the date of installation in your home. If
warranty service is required during the warranty period, contact an authorized InSinkErator
service agent to replace or repair the unit in your home at no cost to you. If your dispenser is
replaced rather than repaired, the warranty on the new unit shall be for the duration of the
remaining portion of the original dispenser’s warranty.
Note: Warranty is determined by unit
serial number and/or date of installation. Purchase or installation receipt may be required to
verify warranty status. When service is required, and for the location of your nearest factory
authorized service center, call toll free 1-800-558-5700.
The foregoing warranty does not apply to damage or inoperation resulting from accident,
alteration, misuse, abuse, improper installation, installation not in accordance with these
instructions or local electrical and/or plumbing codes. We do not assume any responsibility for
consequential damage. Install using genuine InSinkErator
®
manufactured components only.
Use of non InSinkErator components will void your warranty.
Some states do not allow limitations on how long an implied warranty lasts, or the
exclusion or limitations of incidental or consequential damages, so the above limitations or
exclusion may not apply to you. This warranty gives you specific legal rights, and you may
also have other rights which vary from state to state.
This appliance must be grounded. This instant hot water dispenser is equipped with a cord that
has a grounding conductor and a grounding pin. The plug must be connected to an appropriate
outlet that is properly installed and grounded in accordance with all local codes and ordinances.
Do not modify the plug provided with the appliance – if it will not fit the outlet, have a proper outlet
installed by a qualified electrician. Check with a qualified electrician or serviceman if you are in
doubt as to whether the instant hot water dispenser is properly grounded.
WARRANTY INFORMATION
Fire Hazard: To minimize possibility of fire, DO NOT store flammable items such as
rags, paper or aerosol cans near the tank. DO NOT store or use gasoline or other
flammable vapors and liquids in the vicinity of this or any other appliance.
An instant hot water dispenser, like any water heater, has a limited life and will eventually
fail. To avoid possible property damage, this instant hot water dispenser should be
regularly examined for leakage and replaced when necessary. A drain pan, plumbed to an
appropriate drain or outfitted with a leak detector, should be used in those applications
where any leakage could cause property damage.
Electric Shock Hazard: To prevent electrical shock,
disconnect power before servicing unit. Use only a
properly grounded and polarized electric outlet.