Invacare 9873 Trash Compactor User Manual


  Open as PDF
of 4
 
Part No 1075940 3 Transfer Bench
ATTACHING THE BACKREST ASSEMBLY
NOTE: Before performing this procedure, carefully read and understand the Safety
Summary of this instruction sheet.
1. Position transfer bench upside down on a level surface.
NOTE: The backrest attaches to the end closest to the seat arm and MUST be positioned
facing the shower head and/or faucet.
2. Remove the four (4) mounting
screws that secure the seat to the leg
frames.
3. Position backrest onto the leg
frames.
4. Install one (1) mounting screw
through back support tube, leg
frame, and into seat. Repeat for
three (3) remaining mounting
screws.
5. Securely tighten all hardware until
a resistance is felt and all slack is
removed.
FIGURE 2 - ATTACHING THE
BACKREST ASSEMBLY
ADJUSTING LEG EXTENSIONS
NOTE: Before performing this procedure, carefully read and understand the Safety
Summary of this instruction sheet.
1. Select one (1) of the nine (9) adjustment holes located on the lower leg frame.
2. Depress the snap button and slide
the leg extension up or down to the
desired height until snap button
protrudes fully through the
adjustment hole of the leg
extension.
3. Repeat for the other legs.
4. Make sure all four (4) legs are
adjusted so that the transfer bench
sits level inside and outside of the
tub.
FIGURE 3 - ADJUSTING LEG
EXTENSIONS
CLEANING
NOTE: BEFORE using any cleaning products, test an area on the underside of the seat for
any discoloration or staining.
1. Use a mild soap or non-abrasive cleanser and water to clean the transfer bench.
Leg Frame
Back
Support
Tube
Backrest
Seat Arm
Seat
Mounting Screws
Snap Button
Leg Extension
Adjustment
Holes
 previous