Filter
Top Products
Chute
Lid with built-in
Pulp Guard
Pusher
Pulp
Collector
Lid with built-in
Pulp guard
Filter/Blade
7
ASSEMBLY (CONT.)
STEP 4:
Place filter/blade inside receptacle. Rotate
the filter/blade allowing it to settle into
alignment. Press down on rim of filter/blade
firmly to secure.
IMPORTANT: The unit will not start until
filter/blade is secure and firmly in place.
The motor will not
start until the unit is
properly assembled.
STEP 5:
Place lid with built-in pulp guard on top
of receptacle, making certain it is securely
aligned with the pulp guard facing in the
opposite direction of juice spout. Lock lid into
place by lifting locking bar up until it clicks
into grooves located on both sides of the lid.
Make sure locking bar is in the full upright,
locked position.
IMPORTANT: The unit will not start until this
bar is properly locked in place and the pulp
collector is properly assembled.
STEP 7:
Insert pusher into chute. Always use pusher
to feed fruits and vegetables into unit. Push
gently, never force. The blade will do the
work.
STEP 6:
Make sure juice spout is in the downward
position. If the juice spout is left in the upright
position the juice will not flow. It will stay in the
receptacle and may overflow from the sides.
4
5
7
Receptacle
Receptacle
Top
Rim
Juice
Spout
6
DOWNWARD POSITION
UPRIGHT POSITION
Juice Spout