Filter
Top Products
AJ-64 Conveyor Series Technical Manual 7610-003-30-93
Issued: 05-02-2006 Revised: N/A
SECTION 3: PREVENTATIVE MAINTENANCE
47
LUBRICATION CHART FOR DRIVE GEAR
Note: The maintenance procedures detailed here are manufacturer’s instructions for the WINSMITH brand of gear reducer
that is installed on the rack conveyors covered in this manual.
Ambient Temperature -30 - 15°F 16 - 50°F 51 - 95°F 51 - 95°F 96 - 131°F 96 - 131°F
Final Stage Worm Speed
1
up to 2000 FPM up to 2000 FPM up to 450 FPM above 450 FPM up to 450 FPM above 450 FPM
ISO Viscosity Grade 220 460 680 460 680 460
1
AGMA Lubricant No. 5S #7 Compounded #8 Compounded #7 Compounded 8S 7S
Mobil SHC 630 600W Super Extra Hecla Super 600W Super SHC 636 SHC 634
Cylinder Cylinder
American Lubricants SHC-90W AGMA #7 Gear Oil AGMA #8 Gear Oil AGMA #7 Gear Oil N/A N/A
Castrol Tribol 800/220 Tribol 1105-7C Tribol 1105-8C Tribol 1105-7C Tribol 800/680 Tribol 800/460
Chevron Tegra 220 Cylinder Oil W460 Cylinder Oil W680 Cylinder Oil W460 Tegra 680 Tegra 460
Conoco Syncon R & O Inca Oil 460 Inca Oil 680 Inca Oil 460 N/A Syncon R & O
220 460
Exxon (Esso) Teresstic SHP220 Spartan EP 460 Spartan EP 680 Spartan EP 460 Teresstic SHP 680 Teresstic SHP
460
Fiske Brothers SPO-MG SPO-277 SPO-288 SPO-277 N/A N/A
Shell Omala RL 220 Valvata J 460 Valvata J 680 Valvata J 460 Omala RL 680 Omala RL 460
Texaco Pinnacle 220 Vanguard 460 Vanguard 680 Vanguard 460 Pinnacle 680 Pinnacle 460
(1) The sliding velocity in feet per minute (FPM) for standard ratios is determined by multiplying the speed of the worm in RPM by
the factor from the table below. For selecting proper lubricant, use the speed of the worm in the final stage (input RPM divided by
the first stage ratio).