Filter
Top Products
AJ-44C Series Technical Manual 7610-001-76-22
Issued: 03-21-2006 Revised: N/A
SECTION 2: INSTALLATION/OPERATION INSTRUCTIONS
CHANGING THE AJ-44CE/CS DIRECTION OF TRAVEL (CONTINUED)
35
4. Remove the upper wash arm assembly bracket. This step
may require that you have help as the bolts for securing the
bracket to the top of the inner hood are the same bolts that
hold the control box to the hood top. Do not remove the bolts
once the nuts are taken off. Once the bracket is removed,
place the nuts immediately back on the bolts. To hold the bolts
(to keep them from spinning), a 7/16” combination wrench or
7/16” nutdriver will be required in order to hold the bolt head
inside the control box.
Remove the locknuts from the opposite bolts used to hold
down the control box (do not remove the bolts) and secure the
bracket to underside of the hood. The folded part of the brack-
et should be facing the rear of the machine. Immediately tight-
en down the locknuts.
5. Remove the splash shield, which is bolted to the underside
of the hood next to the wash manifold and turn it 180°.
6. Remove the pawl bar and set to the side.
7. Remove the lower wash arm assembly by turning the lock-
ing screw to unlatch it. The entire assembly should then lift
out.
8. Remove the lower wash arm support bracket. Place it to the
side with its locknuts.
Removing bracket (bottom view)
Removing bracket (control box view)
Removing and turning splash shield
Remove the pawl bar by grasping firmly and
lifting up.
Locking screw