Filter
Top Products
Installation Instructions:
1. Identify the appropriate location for the box.
2. Make sure the electrical supply to the dishmachine has been turned off at the supply circuit
breaker.
3. Loosen the two screws in the upper corners of the box and open. (See photo #1)
4. Loosen and remove the four screws to the component mounting plate inside. (Removing the
ground screw will give additional slack.) (See photo #2)
5. Hold the box up to the wall and mark four mounting holes. (See photo #3)
6. Install appropriate wall anchors for the type of wall.
7. Mount the box to the wall.
8. Replace the component mounting plate. Reinstall the ground screw.
9. Close the box and retighten screws.
10. Run flexible conduit to rear of dishmachine and attach with fitting provided.
11. Remove the front kick panel from the dishmachine by loosening the screws under the front
two corners and lifting upward and out.
12. Locate the wire bundle above the thermostat. (See photo #4) There will be four wires (white,
red, blue and white with a red stripe) all with red crimp-type butt splices.
13. Run the five wires from the conduit to the front of the unit and match up color to color with
the wire bundle. Cut wires from the conduit to proper length, if needed.
14. Crimp all wires to matching color on dishmachine. Attach green and yellow wire to ground-
ing lug. Use wire ties to route wires out of the way of moving parts.
15. Reinstall the kick panel on the dishmachine.
16. Locate and remove the white bulkhead plug on the rear of the dishmachine.
17. Install the bulkhead fitting from the kit (bulkhead with a hole through the center) in its place.
(See photo #5) Install one of the compression elbows into the bulkhead fitting. Route the red
chemical tube into the compression elbow and hand tighten only.
18. Locate the rinse injector on the rear of the dishmachine. Remove one of the square headed
plugs. Wrap the compression elbow threads with plumber’s teflon tape and install the elbow into
the hole.
19. Insert a short piece of clear tubing from the kit into the other compression elbow. Route the
white tubing from the dispenser to the compression elbow. Insert white tube through clear tube
in compression elbow and hand tighten only. (See photo #6)
20. Power up the unit and run a cycle and check for leaks.
21. Put the unit back in place.
22. Place the gray stiffeners in the appropriate chemicals. (red for detergent, and white for rinse
aid)
23. Prime each pump until chemical is seen flowing through tube going into the unit.
24. Installation is complete.
Photo #1
Photo #2
Photo #3
Photo #6
Photo #5
Photo #4
7
SECTION 2: INSTALLATION/OPERATION INSTRUCTIONS
INSTALLATION INSTRUCTIONS & DIAGRAMS for the HT-1 & HT-2