Jagermeister JEM Beverage Dispenser User Manual


 
- 17 -
Bottle Stopper Insertion and Removal
IMPORTANT NOTICE:
WHEN REPLACING EMPTY
BOTTLES - DO NOT
DISCARD OR THROW THE
BOTTLE STOPPERS AWAY.
THE BOTTLE STOPPERS
ARE TO BE REUSED AND
ARE NOT DISPOSABLE!
Figure 8 – Screw On Bottle
Stopper
Model JEMUS bottle stoppers are screw on style.
This stopper used in conjunction with the Model
JEMUS bottle well assembly supports up to 1 liter
bottles without the use of a bottle cage. Do not use
these stoppers in older model Jägermeister Tap
Machines.
DO NOT DISCARD OR THROW THE BOTTLE
STOPPERS AWAY. THE BOTTLE STOPPERS
ARE TO BE REUSED AND ARE NOT
DISPOSABLE!
Figure 9 – Screw On
Step 1
Remove the cap from the Jägermeister Bottle
and position the Bottle Stopper above the Bottle.
Figure 10 - Seated
Step 2
Screw onto the threaded neck of the bottle.
Screw on tightly but do not over tighten. A
correctly installed bottle stopper will ensure a
tight seal between the bottle stopper neck and
the bottle.
Figure 11 - Install
Step 3
Unsnap the three (3) dust caps from the bottle
well assembly. Carefully and slowly turn the
bottle upside down and position it directly over
the machine. If any Jägermeister begins to drip
ensure the bottle stopper is securely screwed
on.