Filter
Top Products
Ice maker is not
producing ice
Water filter
indicator light is
red
Ice forms in inlet
tube to ice maker
Refrigerator is
leaking water
34
Confirm ice maker arm is down. See Automatic Ice
Maker page 17.
See Connecting the Water Supply pages 4 and 5.
Turn off water supply and remove kinks.
If kinks cannot be removed, replace tubing.
Water pressure must be between 35 to 100 pounds per
square inch to function properly.
A minimum pressure of 35 pounds per square inch is
recommended for refrigerators with water filters.
See Temperature Controls pages 10,11 and 12 to adjust
controls. Freezer must be between 0° to 2° F (-18° to -
17° C) to produce ice.
See Ice Storage Bin page 16.
See Connecting the Water Supply pages 4 and 5.
Self-piercing and
3
⁄16” saddle valves cause low water
pressure and may clog the line over time. The
manufacturer is not responsible for property damage
due to improper installation or water connection.
If filter is not available, replace with bypass filter.
See Water Filter page 20.
See Filter Status Indicator Light page 19.
Water pressure must be between 35 to 100 pounds per
square inch to function properly.
A minimum pressure of 35 pounds per square inch is
recommended for refrigerators with water filters.
Open saddle valve completely.
See Temperature Controls pages 10,11 and 12. Freezer
temperature should be between 0° to 2° F (-18° to -17° C).
The manufacturer recommends using copper tubing for
installation. Plastic is less durable and can cause
leakage. The manufacturer is not responsible for
property damage due to improper installation or
water connection.
See Connecting the Water Supply pages 4 and 5. Self-
piercing and
3
⁄16”saddle valves cause low water pressure
and may clog the line over time. The manufacturer is
not responsible for property damage due to
improper installation or water connection.
Ice maker arm is up.
Household water supply is not reaching
water valve.
Copper tubing has kinks.
Water pressure is too low.
Check freezer temperature.
Ice bin is not installed properly.
Improper water valve was installed.
Water filter needs to be replaced.
Filter indicator sensor needs to be reset.
Water pressure is too low.
Saddle valve not open completely.
Freezer temperature is too high.
Plastic tubing was used to complete
water connection.
Improper water valve was installed.
PROBLEM
POSSIBLE CAUSES WHAT TO DO
Ice and Water
T
ROUBLESHOOTING
continued…