Filter
Top Products
4
WHEN INSTALLING BELOW
A
WALL OVEN
Warming drawers are suitable for installa-
tion below only certain specified wall oven
models.
See the label attached to the top of the
warming drawer for suitable models.
Drawer overlaps will conceal cut edges on
all sides of the opening.
The rough opening for the drawer
must be:
• Depth: 23-1/2" minimum from inside back
to front of cabinet frame.
• Width: 28-1/2"
• Height: 9-1/4"
• Allow 2" minimum between oven and
drawer cutouts for clearance of over-
laps.
NOTE: If you are installing in frameless
cabinets, it may be necessary to install 1/2"
wide cleats to accept drawer mounting
screws. See drawer to find exact locations
of mounting screws.
NOTE: Electrical receptacle can be in-
stalled as shown for countertop installa-
tions. Do not install receptacle above
the top of the warming drawer cut-
out.
INSTALLATION BELOW A SINGLE OVEN
INSTALLATION BELOW A DOUBLE OVEN
28
1
/
2
"
30"
*NOTE: Additional clearance between cutouts may
be required. Check to be sure that oven supports
above the warming drawer location do not obstruct
the required interior 23
1
/
2
" depth and 9
1
/
4
" height.
28
1
/
2
"
30"
*NOTE: Additional clearance between cutouts may
be required. Check to be sure that oven supports
above the warming drawer location do not obstruct
the required interior 23
1
/
2
" depth and 9
1
/
4
"
height.
2 x 2 or 2 x 4 anti-tip
block against rear
wall 9" from floor to
bottom of block
2”
Min.
10
1
/
2
"
23
1
/
4
"
23
1
/
2
"
Min.
9”
9
1
/
4
"
1" Min. above toekick or adjust
to oven installation height
Oven
cutout
Allow 5/8"
overlap on
all sides
30"
2 x 2 or 2 x 4 anti-tip
block against rear
wall 9" from floor to
bottom of block
2” Min.
10
1
/
2
"
23
1
/
4
"
23
1
/
2
"
Min.
9”
9
1
/
4
"
1" Min. above toekick
Oven
cutout
Allow 5/8" overlap
on all sides
28
1
/
2
"