Filter
Top Products
6
Installation of LP Orifice Spuds
Figure 6
B. Invert Cap in Appliance Pressure Regulator
(See figures 7 and 8.) With the appliance installed, the
regulator is loc ated on the under side of the burner box
on the r ight hand side at the inlet to the gas manifold.
Identify the make of appliance regulator on the unit and
follow the instructions in the appropriate illustration.
Figure 7: Conversion of Maxitrol
Appliance Pressure Regulator
With a quarter, engage slot and r otate cap 1 /8 of a turn
counterclockwise. To remove cap, turn cap o ver and
reinstall.
Figure 8: Conversion of Harper- Wyman
Appliance Pressure Regulator
After conversion, steps A and B have been c ompleted,
check the appearance of each burners’ flame at the Hi and
Lo settings against figure 9 . If the flames appear too large
or too small, review all steps to make sure they wer e
completed correctly.
Figure 9: Flame Appearance at Hi and Lo