Jenn-Air JDB8910 Dishwasher User Manual


 
Controls At A Glance
Cycles Oations
Ultimate Quiet Series I_l Auto Drain• Delay Rinse China Light Normal Heavy Super Sa,itize Heated Extra
Clean Off Resume Only Crystal Wash Wash Wash SetuP [_ry Rinse
Plus
Controlpanel styling variesby model.
Cycles
Auto Clean Select Sanitize with Auto Clean, Heavy, Normal, or
Manufacturer's recommended cycle choice for all day-to- Light Wash to sanitize dishware. At the end of the cycle,
day soil types, when the cycle monitor recognizes that the proper condi-
tions have been met, the SANITIZED light illuminates.
Normal dishloadsvary from day to day. Auto Clean is rec-
ommended because it atttomatic',dly adjusts to each load, Select Extra Rinse to add a rinse to the cycle. An extra
offering the best combination of cleaning, energy consump- rinse helps to improve results in hard water situations. The
tion and water usage for that load. extra rinse is already built into the cycle when Heavy
Standard cycles: Wash is selected.
Select Heated Dry to turn on the heating element during dry
Heavy Wash for enhanced drying results. When Heated Dry is not select-
Long cycle for heavy food soils, ed, towel drying of some items may be necessary and more
Normal Wash moisture may be noticed adhering to the dishwasher interi-
Medium cycle for average food soils.
or. With either dry option, itis normal to notice vapor escap-
Light Wash ing from the door vent.
Short cycle for light food soils.
China/Crystal (select models) To drain the dishwasher and then turn it off, press
Drain/Off once. Press Drain/Off twice to turn the dish-
Short cycle with more gentle cleaning action.
washer off without draining.
Rinse Only
Rinses dishes being held until there is a full load. Controls *Brandnames,arethetrademarksof therespective manufacturer.
odors.
Cycle times shown in the numerical display increase or I n d i c a t o r L i g h t s
decrease, based on each load's soil level, water tempera-
ture and selected options. SANITIZED illuminates at the end of the cycle when con-
ditions have been met to achieve sanitization.
W a t e r U s a g e Note: When Sanitize is selected, cycles are monitored to }
assure sanitization. Unusually low water temperature will
I
I-- --AutoClean I prevent the sanitizationprotocol from being satisfiedand the
I Normal I SANITIZED light will not illuminateat the end of thecycle.
Rinse China Light Heavy CLEAN illuminates at the end of the cycle and remains lit
Only Crystal until the door has been open for 30 seconds continuously.
1 Fill 3 Fills 2 Fills 3 Fills 4 Fills 5 Fills
2.1 5.0 4.1 6.(/ 8.0 9.9 DRY illuminates during the entire dry period and goes out
gallons gallons gallons gallons gallons gallons when the cycle is completed.
WASH illuminates during the prewash and wash portions
of the cycle. In some models, WASH also illuminates dur-
O p t i o n s ingthe final rinse.
Select Super Scrub Plus when washing loads with hard-to- RINSE (select models) illuminates during the final rinse.
remove food soils.
RINSED (select models) illuminates after a Rinse Only
This option can be selected with any cycle (except Rinse cycle.
Only). Depending on the cycle, Super Scrub Plus adds
fills, heat, and/or wash time to the wash cycle. The HEATING DELAY light illuminates when the cycle
is being extended to heat the water to proper temperature.
For baked-on, dried-on soils, select Heavy Wash along with
Super Scrub Plus. The use of an enzyme detergent (such CLEAN and SANITIZED will not reilluminate after a power
as Cascade Plus* or Electrosol Tabs*) is recommended, failureuntil after the next cycle is ran.