Jenn-Air JFC2089HEP Refrigerator User Manual


 
6
I
NSTALLATION
Door Reinstallation
1. Install hinge assemblies:
Install center hinge with Phillips screws.
2. Place hinge side of refrigerator door on center
hinge pin.
Install top hinge with
5
16
” hex head
screws.
3. While holding refrigerator door
upright, tighten down top hinge
with
5
16
” hex head driver.
4. Reconnect two-pin connector.
5. Replace top hinge covers.
Handles
(style varies by model)
This handle style is installed at the factory. Style may
vary by model.
Materials Needed:
3
32
allen wrench
To Remove:
Remove set screw from
handle mounting post
using the
3
32
allen
wrench.
Repeat the procedure on
all posts to remove the
handle.
To replace:
Align handle with the mounting posts.
Fully tighten all set screws to secure handle
in place.
5. Lift top of drawer front
to unhook the drawer
from the slides. Lift
door front out to
remove.
2. While supporting door front, hook supports into
slots located on inside of each slide.
To Install:
1. Pull both rails out to
full extension.
Note
All four drawer bracket supports must be in the
proper slots for the drawer to function properly.
6. Tilt the lower basket front down and set it down
into the basket cradles.
Basket cradle
snap attachments
3. Lower door front into final position.
4. Replace and tighten Phillips screws that were
removed from the drawer slides (select models).
5. Place the basket cradles back onto the drawer
slides. Align basket cradle snaps with the slots on
the drawer brackets and press each cradle
towards the bracket until it clicks.
12828119 Jenn-Air Trio Eng 1/14/05 8:53 AM Page 7