Filter
Top Products
Lift the front of the Automatic Dispenser bin and pull it straight out. Wash the bin
occasionally in mild soap and lukewarm water. To replace the bin, push it all the way
back until the bottom ofthe bin is behindthe raised edge at the front of the shelf it rests
on. Make sure the tabs, at the backof the bin, that turn the spiral auger are positioned
between the prongs from the auger motor.
Prevent ice cubes from missing your glass by holding it as
high as possible (just below the ice chute). Pressthe glass
against the padded lever at the left side of the fountain. To
stopdispensing ice, release pressurejust enough to stopthe
dispensermotor and leave the glassin place to holdthe door
open until icestopsfalling. With a littlepractice,you will learn
to anticipate when to release pressure to prevent an un-
wanted dispense ofice, which occurs each one and one half
seconds.
After installation, itmay take 1 to 2 days to fill the Automatic
Dispenser bin with ice cubes.
To dispensewater, press a container against the padded lever
at the right side ofthe fountain. To stopthe water flow, release
pressure. To minimize splashing, hold the container as high
as possible.
When you first operate your dispenser or after reconnecting
water to your refrigerator,air will escapefrom the dispenserfor
a few minutesbefore water begins toflow. Draw 10 glasses of
water and empty them in the kitchen sink. This will insure
complete filling of the reservoir with fresh water.
16