Filter
Top Products
If you are installing your new refrigerator yourself, pleasefollow these helpful sugges-
tions.
1. Remove base skids, i I-J]L[-j I
2. Remove all exterior and interior tape carefully and ,, ,_ll
retain old tape. Make a small pad of this tape to pick
offany remainingtaperesidues. Thiswill eliminate the
need to use dangerous Solventsof any kind.
3. Remove anddiscard the cantilever shelf packing clips
located just above each shelf where they hook onto
the frame. To remove the red plastic clip, wiggle it
sideways and pull straight out.
4. Select a locationfor your new refrigeratoraway from any heat sources. Allow afree
flow of air through the front base grille.
5. Your model should not be installed where the room temperature will go below
55°,=. because Jtwillnot run frequently enough tomaintain proper temperature in
the freezer.
To enhance its appearance, maintain efficient performance and for proper function of
the ice maker, your refrigerator should be level. Using a carpenter's level, check your
refrigerator to make sureit is levelfront to back and side to side. The front wheels were
adjusted at the factory so the cabinet would be level. However, jarring in transit, or
standing the refrigerator on an uneven floor may cause the cabinet to appear unlevel.
If leveling is necessary, remove the base grille and adjust:
ModelsJRT199, JRT219, JRTD229 TUaNCLOCKWISETO
RAISE CABINET CORNER
TOlock thecabinet in place, turn down one or I ._.
bothlockingfeet, located nearthe frontwheels.
r-,
Rear leveler feet are not required.
ifthe floorisnotlevelanditisnecessaryto raise xt_
the rear of the cabinet, we suggest rolling the
rear wheels on to a piece of plywood or other
TURN COUNTER-CLOCKWISE
shim material, To LOWER CABINET CORNER