Jenn-Air MK27 Oven User Manual


  Open as PDF
of 3
 
Step 3. Cabinet or Wall Opening
Fneopening should be per dimensions described below. All comers should
_esquare. The floor of the opening must be plywood and must be level
_ndcapable of supporting 80 Ibs.
I j, "A" "1
_TE REC_°TACLE _
Model I Dim"A"
MK30 28=1,e"
' iv-_
Fig.7
8V:
Installation Above Lower Oven
....... Note 1: When installing this Kit above a built-in oven, check built-in
The;weight of _le Microwave oven installafion instmctians to determine cutout dimensions
for the (lower) wall oven.
Step4. Assembly of Trim Note 2: For a new installation, the 48" height dimensfon to the bot-
tom of the Cutout for the microwave oven is recommended.
_.. Locate pieces of assembly as indicated in Fig. 5. These include a top, This places the microwave oven bottom at approximately 50"
bottom, right, left, (2) glass assemblies, 6 screws (4 fiat head and 2 from the floor. See figure 8.
truss head), and 4 end caps.
3. insert end caps into the end of the top (see Fig. 5).
1
Assemble
outer frame by attaching top, sides, and bottom with 4 fiat CAUTION ' /
head screws as depicted in Fig. 5. When the microwave oven is installed above a Jenn--Air wall oven, ]
). Attach glass assemblies on left and dght sides by inserting flange into the minimum height dtmenei0n from the bottom of the wall oven
top and attaching with truss head screw in the bottom (see Fig. 5). cutout to the bottom of the microwave cutout:must be main.. I
c'..,side of glass to be flush with outside tdm. rained. ,:: _ _:_ ::"_:_b
EndCaps ................. ........... ": _ "" :i -'_'_.
attco e,---- =_ _.-S.eSt.D3 --_'I I
Ill' Trim I f t I I I#11
Fig. 5 _e J _ Bottom
;top 5. Installation of Microwave Oven
• Plug power cord of oven into receptacle. MK2.7 Kits may be used with microwave model M168, installed above
• Slide the oven into the opening. Be sure the lip of the bottom rail is Jenn-AJr 27" wall oven models beadng manufacturer No. E33658, when
flush with front of cabinet• Center microwave in opening, installed in accordance with Manufacturer's ]nstal[ation
• Attach rail to cabinet with 2 fiat head screws (see Fig. 6). Instructions.These include models W27100, W27200, W27400.
• Attach tnm assembly as shown in Fig. 7. Insert bottom of tnm as-
sembly into rail and rotate upward. Attach top of trim to cabinet with 2 MK30 Kite may be used with microwave model M168, installed above
flat head screws. Jenn-Air 30" wall oven models beadng manufacturer No. E33658, when
__ installed in accordance with Manufacturers Installation Instructions.
These include modets W30100, W30400.
Manufacturer's No. can be obtained from the sedal plate on the
Fig. 6 oven.
- IMPORTANT -
"._ SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE
•_ Part # 210649A
 previous