Jenn-Air MK27 Oven User Manual


  Open as PDF
of 3
 
Microwave Oven
INSTALLATION
INSTRUCTIONS
PART NO. 210649
Built-In Kit
With use of Model M168 Microwave oven.
Step 2. Bottom Rail
A. Removetop brackets and discard
(retain screws - see Fig. 2).
Note: A 27" minimum wide
cabinetmustbeprovided B. Replace large bracket withbracket included intrim kiL
toinstallTrimKitMK27. attaching with screw removed from orJgJnaJ(see Fig. 3).
Note; A 30" minimum wide C. Set microwave on its back so bottom is accessible. Remove
cabinetmustbeprovided leftoutboard screw and corresponding right hand screw from
toinstallTdmKit MK30. bottomfront and attach bottom rail as shownin Figure 4 with
Same screws.
f! f ftT
Step 1. Electrical Requirements ___._____
OBSERVE ALL GOVERNING CODES AND ORDINANCES. _ Fig. 2
A. A 120-Volt, 60Hz, AC, 15 ampere, fused electrical supply is
required (time*delay fuse or cimuit breaker is recommended.)
However, if your home has a cimuit wired and fused for 20
amperes, this is preferred. If you are installinga new cimuit,
_e wired and fused for 20 amperes is recommended. It is
aiso recommendedthat a separate circuitservingonlythis ap-
piiance be provided. Do net use an extension cord.
B. Electrical Connection t
ELECTRICAL GROUND IS REQUIRED ON THISAPPLIANCE. ",_
DO NOT, UNDER ANY CIRCUMSTANCES, REMOVE THE
POWER SUPPLY CORD GROUND PRONG.
For your personal safety, this appliance must be properly _1
grounded and polarized. This appliance is equipped with a _J Fig. 3
power supply cord having a 3-prong grounding plug. To mini-
/
mize possib[e shock hazard, the cord must be pluggedinto a | _ I _.....J J._'ll
mating 3-hole grounding type wall receptacle, grounded in as-
L
cordance with the National _:}ectricaiCode, Ioca_codes and
ordinances. If a mating wall receptacle is not available, it is ----.._
the personal responsibility and obligation of the customer to
have a propedy grounded and polarized 3-holewall receptacle
installed by a qualified electrician. (See Figure 1.)
3-Prong
GroundingF
Ill O)l
IU 0}] _"
PowerSupply -_ r_ //
Co_ _ __ . _-
_ , ; .
<?,
3-HcJle _mur_ing _'_ _" _ :
"ry_ew=_ae_pt,_e Fig. 4 "_ i;'"
Fig.
1
Required Grounding Method
 previous