Filter
Top Products
7
Cabinet-front mounting
7. Grasp sides of compactor drawer and place bottom of
drawer into tracks. Lift at the handle so drawer will go over
drawer stops. Close drawer. Check to see if drawer opens
freely. If the toe plate rubs against floor, see “Adjusting the
To e P late ” for further instructions.
Adjusting the Toe Plate
If the toe plate rubs the floor covering, the toe plate clearance
may be changed as follows:
1. Mark on each side of the toe plate the amount of toe plate
that rubs the floor covering.
2. Remove the drawer from the unit. (See Step 3 in the
“Unpacking” section.)
3. Use a ruler and a pencil or chalk to draw a line between the
marks on each side of toe plate.
4. Use scissors or utility knife to cut toe plate along line.
5. Replace drawer. If toe plate still rubs floor covering, repeat
steps 1-4.
Air Freshener
The solid air freshener system is designed to help control odors
that might develop in the trash. An air freshener disc can be
purchased in department stores (not sold with compactor). Place
the disk-shaped solid air freshener into the air freshener
compartment. The air freshener should last 4 to 6 weeks. It is
used more rapidly when the temperature is high or the air is very
dry.
Changing the Decorative Panel
There are three options for changing the decorative panel:
■
Order an acrylic panel
■
Create a custom panel for use with a trim kit
■ Create a custom panel for installation without trim
To order an acrylic panel or a trim kit, see the “Assistance or
Service” section for information or call the toll-free number on the
cover.
Trim kit panel dimensions
Use these dimension drawings to create a custom panel for use
with a trim kit. Then, follow the installation instructions provided
with the kit.
Flat panel: A ⁷
³²
in. (5.6 mm) thick panel is required. This is the
same thickness as a standard ¹₄ in. plywood or paneling.
Raised panel: The outer section of panel must be ⁷
³²
in. (5.6 mm)
thick to fit into trim. Design raised panel sections using
dimensions shown above.
1. Mounting clip
2. Cabinet
3. Retaining bracket
4. Mounting screw
1
4
3
2
1. Raised panel or decorative trim
2. Outer section of panel
23
"
13
1
6
(
60.5 cm
)
14 "
5
8
(
37.2 cm
)
23 "
13
1
6
(
60.5 cm
)
1 "
1
4
(
32 mm
)
14 "
5
8
(
37.2 cm
)
"
7
32
(
5.6 mm
)
"
5
16
(
8 mm
)
both sides
1
2
"
5
16
(
8 mm
)