Jenn-Air W10208727A Dishwasher User Manual


 
23
Remove towel from dishwasher. Reinstall the lower dish
rack.
Remove towel and replace
lower dishwasher rack
7
If needed, see website for animated representation
of this step. Visit www.jenn-air.com/anchoring under
FAQ tab.
Check that grounding clip is attached to the lower panel.
Position the lower panel behind the access panel. On some
models there is insulation on the access panel which must
fall behind the insulation on the lower panel.
1
Reinstall access panels
Gr
Gr
ounding
ounding
clip
clip
Grounding
clip
Insulation
Insulation
(on some models)
Lower
panel
Access
panel
Complete Installation
Check that the lower edge of the lower panel contacts
the floor. Adjust if necessary.
3
Check lower panel edge
Hold the two panels together and place them against
dishwasher leg. Using a Phillips or 1/4 screwdriver, reinstall
the screws through the holes in the access panel and the
slots in the lower panel.
2
Reinstall access panels
Tighten access panel screws.
4
Tighten screws
plastic
button
6
Check side attachment
If securing with a side attachment, check that sides of door
do not rub against the screw heads. If they do, dishwasher
must be re-centered. When dishwasher is properly centered,
replace plastic buttons.