Filter
Top Products
9
Prepare Custom Wood Door Panels
IMPORTANT: For an armoire installation, instead of drilling holes
along the top edge(s) of the custom door panel(s), you must
adjust the placement of the drilling template (provided with the
refrigerator).
NOTES:
■ No template adjustment is needed for the bottom edge of the
door panel(s).
■ No template adjustment is needed for the custom freezer
drawer panel.
1. Align the drilling template on the back of the custom
refrigerator door panel so that the top of the template is offset
6³⁄₄" (17.2
cm) from the top of the refrigerator door panel.
NOTE: The only offset dimension is the 6³⁄₄" (17.2 cm) offset
from the top of the door panel.
2. Continue to use the template as you normally would along
the bottom, handle side of the door panel.
Complete Installation
IMPORTANT: Return to the instructions provided with your refrigerator to complete the installation. See “Prepare Custom Overlay
Panels” in the Installation Guide.
A. Top of custom refrigerator door panel
B. Drilling template
C. Bottom of custom refrigerator door
panel
6B\,“
(16.8 cm)
A
C
B