Filter
Top Products
22
4. Repeat steps 1 through 3 to install the second door panel.
5. Using slotted hex head screws (provided with refrigerator),
attach the mounting bracket (factory installed), located at the
bottom of the refrigerator and freezer doors, to the respective
door panels. Do not fully tighten the screw.
Install Top Grille Panel
Standard Installation - Flush Grille
1. Hook the panel brackets onto the mounting bolts extending
from the top of the refrigerator.
2. Pull the grille panel down slightly to lock into place.
Integrated Installation - Full Height Grille
1. Align the bracket on each side of the top grille panel with the
mounting bolts.
2. Push the grille panel forward until the bracket snaps into
place.
Door Swing Adjustment
It may be necessary to adjust the swing of the door. Make sure the
refrigerator door(s) can open freely. If the door(s) opens too wide,
install the door stop pin (provided with refrigerator).
1. Hold the door open to a position that is less than 90°.
2. Insert the door stop pin into the top hinge in the hole shown.
3. Using a ⁵⁄₃₂" hex key, tighten the door stop pin.
Complete Installation
1. Use the installation block to measure the gaps between the
panels and adjacent cabinets.
■ Custom wood overlay panels may be made with a ³⁄₈"
(0.95 cm) or ¹⁄₈" (0.32 cm) gap between the panel and
cabinets and a ¹⁄₈" (0.32 cm) gap between the freezer and
refrigerator door(s) and the door(s) and top grille.
■ All purchased panel kits require a ³⁄₈" (0.95 cm) gap
between the panel and the cabinets and a ¹⁄₈" (0.32 cm)
gap between the freezer and refrigerator door(s), and the
door(s) and top grille.
A. Bottom hinge
B. Mounting bracket
A. Top grille panel
B. Cabinet sides
A. Panel brackets
B. Grill trim piece
A B
B BA
A
B
A. Door stop pin hole
A. Adjacent cabinet
B. Installation block
C. Panel on door
A
B
A
C