Filter
Top Products
2) Turn on the machine by pressing the line button and the machine will start to charge water. Wait for
the water to come out of the rinse arms.
Caution: if the tank door is not closed, the machine will not charge the water, so check the door
by looking inside the machine baskets outlet.
3) Now the booster tank should be full, so start the quick heating of the booster. Turn off
the machine, open one of the machine doors, and at the same time press buttons C and D for a few seconds
until the wording Key 00 appears.
4) Go to Key 01 by pressing button C and confirm with D.
5) The wording QUIK READY NO will appear afterwards. Press C to change the status to Yes.
Keep the line button pressed until you see this again: . Then re-start the machine
and the quick heating will be activated. Lastly, wait until the machine is completely filled
.
4.7 Adjusting the controls
The table below indicates the requirements and default settings of the dishwasher:
minimum washing temperature
170 °F (75°C)
minimum
rin
s
ing
temperature
190 °F
(88°C)
inten
s
i
v
e
w
a
s
hing program (speed
1)
150
r
a
c
k
s/h
quick
w
ashing
program (speed
2)
200
r
a
c
k
s/h
Fil
l
ing
h
ose
26.4 mm (3/
4
")
Max. incoming
w
a
ter temp
e
rature
140 °F
(60 °C)
Min. incoming water pressure
100 kPa (14.5 psi)
Max. incoming
w
a
ter pres
s
ure
345 k
P
a (50
p
s
i)
W
a
ter h
a
rdness (r
e
c
omme
n
ded)
6 (Fr
e
n
c
h
d
eg
r
e
e
s
)
Water fl
o
w
rate
20
l/min.
(5.3
gpm)
For viewing the temperatures and operating times:
By keeping the C button pressed for approximately 4 seconds, the instant temperature of the booster and of
the tank can be viewed. The number of daily hours and of the machine's working totals of the machine’s life
will also run across the display.
6