Filter
Top Products
In this fully integrated appliance the controls are located on the
top of the door.When selecting a programme, the door needs to
be open.
1. Check that the baskets have
been loaded correctly and that
the spray arms can rotate freely
2. Turn on the water tap
3. Press the On/Off button
The indicator lights of the programme selection buttons
illuminate.
4. Setting and starting the
programme
To select a programme, press the button of the
programme you wish to select (see "Washing
programmes" chart).
The corresponding indicator light remains illuminated
while the other programme buttons indicator lights turn
off. In the digital display will appear, flashing, the running
time (in minutes) of the programme that has been set.
Close the dishwasher’s door, the programme will start
automatically.
Setting and starting the programme with
the delay start
Once the washing programme has been selected press the
delay start button, the corresponding indicator light will
illuminate and 1h appears in the digital display.
Press the delay start button until the number of hours
desired (from 1 hour up to 19 hours) appear in the digital
display.
Close the dishwasher door, the countdown starts
automatically and will decrease with steps of 1 hour.
The opening of the door will not modify or interrupt the
countdown.
Once the delay start has elapsed the washing programme
will start automatically.
NOTE:The start of the programme or the countdown of
the delay start will occur only after the closure of the
door, until this moment it is possible to modify the set
made.
NOTE: Once the washing programme has started, a
point-shaped optical signal appears on the floor beneath
the dishwasher’s door.This optical signal will remain
illuminated for all the duration of the washing programme.
If the appliance has been installed higher up with a
furniture door mounted flush, the optical signal will be no
longer visible.
5. To interrupt or cancel a washing
programme in progress
Interrupt or cancel a washing programme in
progress ONLY if it’s absolutely necessary.
Important! Hot steam may escape when the door
is opened. Open the door carefully.
Interrupt a washing programme in
progress
Open the dishwasher door; the programme will stop.
Close the door; the programme will start from the point
at which it was interrupted.
Cancel a washing programme in progress
Open the dishwasher door.
Press simultaneously function buttons 2 and 3 for about 2
seconds, the indicator light of the button corresponding to
the running programme starts flashing.After about 2
seconds the indicator lights of all the programme selection
buttons will illuminate, this means that the running
programme has been cancelled and that the machine has
returned to setting mode.
If a new washing programme is to be selected, check that
there is detergent in the detergent dispenser.
6. To cancel a delay start in
progress
To cancel a delay start in progress you have to reset the
dishwasher; follow the same instructions given in "Cancel
a washing programme in progress". Cancelling a delay start
involves also the cancelling of the set washing programme.
In this case you have to set the washing programme again.
7. End of the washing programme
The dishwasher will automatically stop and an audible
signal informs you of the end of the washing programme.
When the washing programme has ended, the optical
signal on the floor beneath the dishwasher’s door will turn
off. Open the dishwasher door only when this optical
signal turns off.
Open the dishwasher’s door, leave it ajar and wait a few
minutes before removing the dishes; in this way they will
be cooler and the drying will be improved.
In the digital display appears 0, only in this case the
programme has ended.
Switch off the dishwasher by pressing the On/Off button.
Starting a washing programme
21