Filter
Top Products
b) Setting electronically
The dishwasher must be switched off
NOTE: the electronic setting of the water softener is
possible ONLY with the Multi-tab function deactivated.
The dishwasher is factory set at level 5.
1. Press the On/Off button.The indicator lights of the
programme selection buttons will illuminate (setting mode).
If only one programme button indicator light is on, this means that
a washing programme is set.The programme must be cancelled:
press simultaneously function buttons 2 and 3 for about 2 seconds.
All programme indicator lights will illuminate indicating that the set
programme has been cancelled and the machine is now in setting
mode.
2. Press simultaneously function buttons 2 and 3, until the
indicator lights of function buttons 1, 2, and 3 start flashing.
3. Press function button 1, the indicator lights of function
buttons 2 and 3 turn off while the indicator light of function
button 1 goes on flashing, the digital display indicates the
current level and a sequence of intermittent audible signals are
heard. The current level is indicated by the number visible in
the display and the number of intermittent audible signals
heard.
Example:
displayed + 5 audible signals = level 5.
4. To change the level, press function button 1. Each time the
button is pressed the level changes. (For the selection of the
new level see the chart).
Examples:
if the current level is 5, by pressing function button 1 once,
level 6 is selected.
if the current level is 10, by pressing function button 1 once,
level 1 is selected.
5. To memorise the operation, switch off the dishwasher by
pressing the On/Off button.
Filling with dishwasher salt
Only use salt specifically designed for use in dishwashers.
All other types of salt not specifically designed for use in
a dishwasher, especially table salt, will damage the water
softener.
Only fill with salt just before starting one of the
complete washing programmes.
This will prevent any grains of salt or salty water, which
may have been spilt, remaining on the bottom of the
machine for any period of time, which may cause
corrosion.
To fill:
1. Open the door, remove the lower basket and unscrew the
cap of the salt container by turning it anticlockwise.
2. Pour 1 litre of water inside the container (this is necessary
only before filling with salt for the first time).
3. Using the funnel
provided, pour in the salt
until the container is full.
4. Replace the cap making
sure that there is no
trace of salt on the
screw thread or on the
gasket.
5. Replace the cap tightly
turning it clockwise until it stops with a click.
The salt container will require topping up periodically.You are
reminded of this by the salt indicator light on the control panel
which comes on when the salt has finished.
The salt indicator light on the control panel can remain
illuminated for 2-6 hours after the salt has been
replenished, assuming the dishwasher remains switched
on. If you are using salts that take longer to dissolve then
it will take longer.The function of the machine is not
affected.
Do not worry if water over flows from the unit when filling with
salt, this is quite normal.
13