Filter
Top Products
6
When the hob is firstWhen the hob is first
When the hob is firstWhen the hob is first
When the hob is first
installedinstalled
installedinstalled
installed
Once the hob has been installed, it is
important to remove any protective
materials, which were put on in the
factory. The manufacturer will not
accept liability, should the above
instructions or any of the other safety
instructions incorporated in this book
be ignored.
InstallationInstallation
InstallationInstallation
Installation
IMPORTANT:IMPORTANT:
IMPORTANT:IMPORTANT:
IMPORTANT:
This hob must be
installed according to the instruction
supplied, and by
qualified andqualified and
qualified andqualified and
qualified and
competent personnelcompetent personnel
competent personnelcompetent personnel
competent personnel to the relevant
National Standards.
Any gas installation must be carriedAny gas installation must be carried
Any gas installation must be carriedAny gas installation must be carried
Any gas installation must be carried
out bout b
out bout b
out b
y a GAS SAFE REGISTER installery a GAS SAFE REGISTER installer
y a GAS SAFE REGISTER installery a GAS SAFE REGISTER installer
y a GAS SAFE REGISTER installer
..
..
.
The manufacturer will not accept liability,
should the above instructions or any of the
other safety instructions incorporated in this
book be ignored.
On the end of the shaft, which includes the
G 1/2" threaded elbow, adjustment is fixed
so that the washer is fitted between the
components as shown in the diagram. Screw
the parts together without using excessive
force.
Gas ConnectionGas Connection
Gas ConnectionGas Connection
Gas Connection
Connection to the gas supply should be with
either rigid or semi-rigid pipe, i.e. steel or
copper.
The connection should be suitable for
connecting to R 1/2” (1/2 BSP male thread).
When the final connection has been made, it
is essential that a thorough leak test is carried
out on the hob and installation.
Ensure that the main connection pipe does
not exert any strain on the hob.
It is important to install the elbow
correctly, with the shoulder on the end
of the thread, fitted to the hob
connecting pipe.
Failure to ensure the correct assembly
will cause leakage of gas.
A)A)
A)A)
A) End of shaft with nut
B)B)
B)B)
B) Washer
C)C)
C)C)
C) Elbow
Instructions for the InstallerInstructions for the Installer
Instructions for the InstallerInstructions for the Installer
Instructions for the Installer