Filter
Top Products
7
Electrical ConnectionsElectrical Connections
Electrical ConnectionsElectrical Connections
Electrical Connections
THIS HOB MUST BE EARTHIS HOB MUST BE EAR
THIS HOB MUST BE EARTHIS HOB MUST BE EAR
THIS HOB MUST BE EAR
THEDTHED
THEDTHED
THED
..
..
.
Any electrical work required to install this hob should
be carried out by a qualified electrician or competent
person, in accordance with the current regulations.
Electrical RequirElectrical Requir
Electrical RequirElectrical Requir
Electrical Requir
ementsements
ementsements
ements
Any permanent electrical installation must comply with the
latest I.E.E. Regulations and local Electricity Board
regulations. For your own safety this should be undertaken
by a qualified electrician, e.g. your local Electricity Board,
or a contractor who is on the roll of the National Inspection
Council for Electrical Installation Contracting (NICEIC).
Electrical Connections
This hob is designed to be connected to a 230 V 50 Hz AC
electrical supply.
Before switching on, make sure the electricity supply voltage
is the same as that indicated on the hob rating plate. The
rating plate is located on the bottom of the hob. A copy is
attached on the back cover of this book.
The hob is supplied with a 3 core flexible supply cables.
This has to be provided with a proper plug, able to support
the load marked on the identification plate. To connect the
plug to the cable, follow the recommendation given in diagram
aside. The plug has to be fitted in a proper socket.
In the event of having to change the fuse, a 3amp ASTA
approved (BS 1362) fuse must be used.
Should the plug need to be replaced for any reason, the
wires in the mains lead are coloured in accordance with the
following code:
Green and Yellow - Earth
Blue - Neutral
Brown - Live
— Connect the green and yellow (earth) wire to the
terminal in the plug which is marked with the
letter 'E' or the earth symbol or coloured green
and yellow.
— Connect the blue (neutral) wire to the terminal
in the plug which is marked with the letter 'N' or
coloured black.
— Connect the brown (live) wire to the terminal in
the plug which is marked with the letter 'L' or
coloured red.
Upon completion there must be no cut, or stray strands of
wire present and the cable clamp must be secure over the
outer sheath.
A cut off plug inserA cut off plug inser
A cut off plug inserA cut off plug inser
A cut off plug inser
ted into a 13 amp sockted into a 13 amp sock
ted into a 13 amp sockted into a 13 amp sock
ted into a 13 amp sock
etet
etet
et
is a serious safis a serious saf
is a serious safis a serious saf
is a serious saf
ety (shock) hazarety (shock) hazar
ety (shock) hazarety (shock) hazar
ety (shock) hazar
d.d.
d.d.
d.
Ensur Ensur
Ensur Ensur
Ensur
e thate that
e thate that
e that
the cut off plug is disposed of safthe cut off plug is disposed of saf
the cut off plug is disposed of safthe cut off plug is disposed of saf
the cut off plug is disposed of saf
elel
elel
el
yy
yy
y
..
..
.
PP
PP
P
ermanent Connectionermanent Connection
ermanent Connectionermanent Connection
ermanent Connection
In the case of a permanent connection, it is necessary that
you install a double pole switch between the hob and the
electricity supply (mains), with a minimum gap of 3 mm
between the switch contacts and of a type suitable for the
required load in compliance with the current electric
regulations.
The switch must not break the yellow and green earth cable
at any point.
EnsurEnsur
EnsurEnsur
Ensur
e that the hob supple that the hob suppl
e that the hob supple that the hob suppl
e that the hob suppl
y cable does noty cable does not
y cable does noty cable does not
y cable does not
come into contact with surfaces withcome into contact with surfaces with
come into contact with surfaces withcome into contact with surfaces with
come into contact with surfaces with
temperaturtemperatur
temperaturtemperatur
temperatur
es higher than 50 deg.es higher than 50 deg.
es higher than 50 deg.es higher than 50 deg.
es higher than 50 deg.
C C
C C
C
..
..
.
Min. size Cable/flexMin. size Cable/flex
Min. size Cable/flexMin. size Cable/flex
Min. size Cable/flex
Cable / flex typeCable / flex type
Cable / flex typeCable / flex type
Cable / flex type
FuseFuse
FuseFuse
Fuse
0.75 mm
2
H05 V2V2-F (T90) 3 A
SupplSuppl
SupplSuppl
Suppl
y cable ry cable r
y cable ry cable r
y cable r
eplacementeplacement
eplacementeplacement
eplacement
The cable used to connect the hob to the electrical supply
must comply to the specifications given below.
NeutralNeutral
NeutralNeutral
Neutral
Earth (yellow/green)Earth (yellow/green)
Earth (yellow/green)Earth (yellow/green)
Earth (yellow/green)
The manufacturer declines any liability shouldThe manufacturer declines any liability should
The manufacturer declines any liability shouldThe manufacturer declines any liability should
The manufacturer declines any liability should
these safety measures not be observed.these safety measures not be observed.
these safety measures not be observed.these safety measures not be observed.
these safety measures not be observed.