John Lewis JLBIGH702 Range User Manual


 
8
1. IGNITOR SWITCHES1. IGNITOR SWITCHES
1. IGNITOR SWITCHES1. IGNITOR SWITCHES
1. IGNITOR SWITCHES
2. IGNITOR UNIT2. IGNITOR UNIT
2. IGNITOR UNIT2. IGNITOR UNIT
2. IGNITOR UNIT
Wiring DiagramWiring Diagram
Wiring DiagramWiring Diagram
Wiring Diagram
2
1
N
L
N
1
2
3
4
5
6
L
N
Fault FindingFault Finding
Fault FindingFault Finding
Fault Finding
PrPr
PrPr
Pr
eliminareliminar
eliminareliminar
eliminar
y Electrical Systemsy Electrical Systems
y Electrical Systemsy Electrical Systems
y Electrical Systems
CheckCheck
CheckCheck
Check
A.A.
A.A.
A.
EAR EAR
EAR EAR
EAR
TH CONTINUITY CHECKTH CONTINUITY CHECK
TH CONTINUITY CHECKTH CONTINUITY CHECK
TH CONTINUITY CHECK - Appliance
must be electrically disconnected - meter set on W
(Ohms) x 1 scale and adjust zero if necessary.
a) Test leads from any appliance earth point to earth
pin on plug. Resistance should be less than 0.1 W
(Ohm), check all earth wires for continuity and all
contacts are clean and tight.
B.B.
B.B.
B.
INSULA INSULA
INSULA INSULA
INSULA
TION CHECKTION CHECK
TION CHECKTION CHECK
TION CHECK - Appliance electrically
disconnected, all switches ON.
a) meter set on W (Ohms) x 1 scale.
Test leads from L to N in appliance terminal block.
If meter reads «0» then there is a short circuit.
b) meter set on W (Ohm) x 100 scale.
Repeat test with leads from L to E. If meter reads
less than ¥ (infinity) there is a fault.
NOTE - Should it be found that the fuse has failed but
no fault is indicated - a detailed continuity check (i.e.
by disconnecting and checking each component) is
required to trace the faulty component.
It is possible that a fault could occur as a result of
local burning/arcing but no fault could be found under
test. However a detailed visual inspection should reveal
evidence of burning around the fault.
STARTSTART
STARTSTART
START
Isolate appliance
and carry out:
A:A:
A:A:
A: Earth Continuity
check.
Has inlet fuse blown?
Carry out:
B:B:
B:B:
B: Insulation check.
Electricity supply
should now be
satisfactory.
Inlet wiring
faulty.
Rectify any
fault.
Isolate appliance and
carry out:
B:B:
B:B:
B: Insulation check.
Rectify any fault
including replacing
fuses as necessary.
Brown
Blue
Green
Yellow
Green
Yellow
Brown
Blue
NONO
NONO
NO
YESYES
YESYES
YES
NONO
NONO
NO
YESYES
YESYES
YES